chapter 7 transmission media 2014/saman... · 2017-01-22 · * twisted-pair cable, coaxial cable,...
TRANSCRIPT
7.1
Chapter 7
Transmission Media
Copyright © The McGraw-Hill Companies, Inc. Permission required for reproduction or display.
7.2
Figure 7.1 Transmission medium and physical layer
7.3
Figure 7.2 Classes of transmission media
7.4
7-1 GUIDED MEDIA
Guided media, which are those that provide a conduit
from one device to another, include twisted-pair cable,
coaxial cable, and fiber-optic cable.
Twisted-Pair Cable
Coaxial Cable
Fiber-Optic Cable
Topics discussed in this section:
7.5
Figure 7.3 Twisted-pair cable
7.6
Effect of Noise on Parallel Lines
7.7
Noise on Twisted-Pair Lines
7.8
Figure 7.4 UTP and STP cables
7.9
Table 7.1 Categories of unshielded twisted-pair cables
UTP ConnectorsFigure 7-9
WCB/McGraw-Hill The McGraw-Hill Companies, Inc., 1998
7.11
Figure 7.5 UTP connector
7.12
Figure 7.6 UTP performance
7.13
Figure 7.7 Coaxial cable
7.14
Table 7.2 Categories of coaxial cables
7.15
Figure 7.8 BNC connectors
7.16
Figure 7.9 Coaxial cable performance
7.17
Figure 7.10 Bending of light ray
How is light guided down the fiber optic cable in the core? This occurs because the core and cladding have different indices
of refraction with the index of the core, , always being greater than the index of the cladding, . If a light ray is injected and
strikes the core-to-cladding interface at an angle greater than the critical angle then it is reflected back into the core. Since the
angle of incidence is always equal to the angle of reflection the reflected light will again be reflected. The light ray will then
continue this bouncing path down the length of the fiber optic cable. If the light ray strikes the core-to-cladding interface at
an angle less than the critical angle then it passes into the cladding where it is attenuated very rapidly with propagation
distance.
7.18
Figure 7.11 Optical fiber
Basically, a fiber optic cable is composed of two concentric layers termed the core
and the cladding. The core and cladding have different indices of refraction with the
core having and the cladding . Light is piped through the core
7.19
Figure 7.12 Propagation modes
7.20
Figure 7.13 Modes
7.21
Table 7.3 Fiber types
7.22
Figure 7.14 Fiber construction
7.23
Figure 7.15 Fiber-optic cable connectors
7.24
Figure 7.16 Optical fiber performance
7.25
7-2 UNGUIDED MEDIA: WIRELESS
Unguided media transport electromagnetic waves
without using a physical conductor. This type of
communication is often referred to as wireless
communication.
Radio Waves
Microwaves
Infrared
Topics discussed in this section:
7.26
Figure 7.17 Electromagnetic spectrum for wireless communication
7.27
Figure 7.18 Propagation methods
7.28
Table 7.4 Bands
7.29
Figure 7.19 Wireless transmission waves
7.30
Figure 7.20 Omnidirectional antenna
7.31
Radio waves are used for multicast
communications, such as radio and
television, and paging systems.
Note
7.32
Figure 7.21 Unidirectional antennas
7.33
Microwaves are used for unicast
communication such as cellular
telephones, satellite networks,
and wireless LANs.
Note
7.34
Infrared signals can be used for short-
range communication in a closed area
using line-of-sight propagation.
Note
7.35
Transmission Media
* Transmission media lie below the physical layer.
* A guided medium provides a physical conduit from one device to another.
* Twisted-pair cable, coaxial cable, and optical fiber are the most popular types of guided media.
* Twisted-pair cable consists of two insulated copper wires twisted together. Twisting allows each wire to have
approximately the same noise environment.
* Twisted-pair cable is used in telephone lines for voice and data communications.
* Coaxial cable has the following layers (starting from the center): a metallic rod-shaped inner conductor, an insulator
covering the rod, a metallic outer conductor (shield), an insulator covering the shield, and a plastic cover.
* Coaxial cable can carry signals of higher frequency ranges than twisted-pair cable.
* Coaxial cable is used in cable TV networks and traditional Ethernet LANs.
* Fiber-optic cables are composed of a glass or plastic inner core surrounded by cladding, all encased in an outside
jacket.
* Fiber-optic cables carry data signals in the form of light. The signal is propagated along the inner core by reflection.
* Fiber-optic transmission is becoming increasingly popular due to its noise resistance, low attenuation, and high-
bandwith capabilities.
* Signal propagation in optical fibers can be multimode (multiple beams from a light source) or single-mode (essentially
one beam from a light source).
* In multimode step-index propagation, the core density is constant and the light beam changes direction suddenly at
the interface between the core and the cladding.
* In multimode graded-index propagation, the core density decreases with distance from the center. This causes a
curving of the light beams.
* Fiber-optic cable is used in backbone networks, cable TV networks, and Fast Ethernet networks.
* Unguided media (usually air) transport electromagnetic waves without the use of a physical conductor.
* Wireless data is transmitted through ground propagation, sky propagation, and line-of-sight propagation.
* Wireless data can be classifed as radio waves, microwaves, or infrared waves.
* Radio waves are omnidirectional. The radio wave band is under government regulation.
* Microwaves are unidirectional; propagation is line of sight. Microwaves are used for cellular phone, satellite, and
wireless LAN communications.
* The parabolic dish antenna and the horn antenna are used for transmission and reception of microwaves.