chapter 2: rhythm and pitch musical notation. key terms notes rests dotted notes dotted rests ties...
TRANSCRIPT
Chapter 2:Rhythm and Pitch
Musical
Notation
Key Terms
Notes
Rests
Dotted notes
Dotted rests
Ties
Slurs
Legato
Staccato
Triplet
Time signatures
Staff
Ledger lines
Clefs
Naturals
Key signatures
Scores
Notation
Many cultures notate, or write down, their music in some way
Notation uses a complex set of symbols to represent pitch, duration, dynamics, expression, and so on
Even if you cannot read music, a basic knowledge of musical notation can help you follow along and understand concepts more easily
Pitch and Time
Just as on a graph:Pitch measured vertically, from low to high
Time measured horizontally, from left to right
Rhythmic Notation
Note valuesNote values express duration of notes•Durations are relative and proportional •A whole note equals two half notes; a half note
equals two quarter notes; and so on•Names based on fractions of whole note (half,
quarter, eighth, etc.)•Actual duration depends on tempo
White notes are longer than black notesThe more flags or beams, the shorter
Note Values
Flags and Beams
Flags and beams group together short notes within a beat
They make rhythms easier to read
Rests
Represent the silences between notes or phrases
Each note value has a corresponding rest, a silence of equal duration
Short rests have flags that correspond to the flags and beams of short notes
Rest Values
Dotted Rhythms
A dot placed after (to the right of) a note or rest makes it half again as long (150% of original)
Dotted rhythms mix longer dotted notes with shorter undotted notes
Ties
Any two or more notes (same pitch!) can be tied together to make one long duration
Legato
SlursLook like ties, but they connect two or more different pitches
Indicate that the performer must move smoothly from one note to the next, with no gap in the sound
Staccato
Staccato DotsDots placed above or below note heads indicate that the notes should be played staccato, in a detached manner
Musicians often play a staccato quarter note as if it were an eighth note followed by an eighth rest
Triplets
Notes normally divide into two or four equal parts
Triplets can be used to divide a note into three equal parts
Three notes are bracketed together and/or marked with the number 3•Quarter note = two eighth notes = three eighth-
note triplets
Meter
MeasuresBasic time unit chosen for a piece of music
Vertical bar lines separate one measure from the next
Measures are normally equal in length
Meter
Time signaturesFound on the staff at the beginning of the piece
Top number = number of beats in each measure
Bottom number = note value of the beat
Pitch Notation
Seven letter names (ABCDEFG) assigned to seven original pitches of diatonic scale
Letter names re-used in every octave
Octaves often distinguished by numbers (c1 or c2) or prime marks (A’ or A”)
Middle C (c1) is just left of the middle of the keyboard, under the maker’s name
The Staff
To specify exact pitches, notes are placed on a five-lined staff
Notes can be placed on a line or in the spaces between lines
Ledger lines temporarily extend the number of lines in a staff when higher or lower notes are needed
Clefs
Clef signs at the beginning of each staff identify a reference pitch (G clef or F clef)
Clefs enable musicians to quickly identify specific pitches on any line or space
Most common are treble clef (G clef) and bass clef (F clef)
Clefs
Middle C is first ledger line above bass clef and first ledger line below treble clef•Since these clefs hardly overlap, they are often
used together to notate a maximum span of pitches
Clefs
Piano music brackets treble and bass clefs together in a grand staff
With ledger lines, the grand staff can be used to notate every pitch on the piano keyboard
Sharps and Flats
Letter names identify the white keys on the piano keyboard
Sharps and flats are required to identify the black keys
In music notation, we write sharps and flats just to the left of a note head
In written prose or when speaking, we say the letter name first (C sharp or B flat)
Sharps and Flats
Sharps
To find a sharped note on the keyboard:•First find the white key for the letter name•Then find the key just above it (to the right!)•C sharp is the black key just above C• (B sharp is the white key just above B!)
Flats
To find a flatted note on the keyboard:•First find the white key for the letter name•Then find the key just below it (to the left!)•B flat is the black key just below B• (C flat is the white key just below C!)
Naturals
Naturals are used to cancel a sharp or a flat (to revert to the white key)
They are used when a sharped or flatted note is followed by a “normal” version of the same note
(Bar lines automatically cancel added sharps or flats)
Key Signatures
Most scales consistently use certain sharps or flats throughout a piece
Writing in those sharps or flats every time they appear takes time and adds clutter
Instead, composers put them in a key signature, found just after the clef at the beginning of each staff
Key Signatures
These two tunes sound the same, but the version with a key signature:
Looks nicer than the version without:
Scores
Music for a melody instrument (violin, trumpet, etc.) is written on a single staff
Scores
Music for keyboard instruments is written on two staves: one for each hand
Scores
Music for two or more instruments and/or voices is written in scores
Scores contain the music for every voice and instrument (every part) in a given piece
Parts are lined up vertically
In general, high sounding instruments go on top, low ones on the bottom
Scores
Scores can be simple, with just a few parts:
Or more complex (next slide):
Scores