chapter 2 linear motion 2.1 motion is relative when we describe something in motion, we are...
TRANSCRIPT
2.1 Motion Is RelativeWhen we describe something in motion, we are
comparing it to something else.For example:
A car is driving 45 miles per hour:
You only know it is moving because the road and trees around it are staying still.
2.1
Is it possible for an object that appears to be at rest, move?
Yes, even as we stand still we are hurtling through space.
2.1This means when we describe motion we do it relative to
something:The train is leaving the station or is the station leaving the
train?A car in the Indy 500 travels 500 miles in the race but
ends up at the same point.On the school bus traveling at 30 mph you throw a ball to
a classmate, how fast is the ball moving?
2.2 SpeedSpeed is a “scalar quantity” – this means it does not include
direction.
Ex: I am running at 10mph, but I don’t tell you where – this is speed.
Speed is the distance covered divided by the time it takes. (mi/h; m/s; km/hr)
Lightning Bolt Unbelieveable Is that possible?
2.2 SpeedSpeed is a measure of how fast something is
moving. We think of it in two ways:Instantaneous speedAverage speed
Speed racers
2.2 Instantaneous Speed – speed at a particular moment You are in a car heading downtown, and you can see from the speedometer
your speed is 40 mi/h (or mph).
Downtown is 10 miles away at this speed. How long would it take you?
Is this true?
2.2 Average Speed It would take us a lot longer than 15 minutes to drive
downtown because of the traffic where we have to slow, stop, start, accelerate, slow, stop, etc., etc,.
Therefore in planning a trip we think about average speed Avg. speed = TOTAL distance covered/timeS = d/t
2.2 Average SpeedIf downtown is 10 miles and it will take me 30 minutes then
my average speed is 20 mi/h.
This is a lot different from my Instantaneous Speed of 40 mi/h.
If we know our average speed and the time traveled we can arrange the formula to tell us our distance traveled.
Total distance = avg. speed X time
What is the speed of a man running 8 miles in 2 hours?
Answer:
s = d/t
8 miles (total distance) / 2 hours (time interval)
s = 8/2 = 4 miles/hour
If a cheetah can maintain a constant speed of 25 m/s, it will cover 25 meters every second. At this rate, how far will it travel in 10 sec? In 1 min?
S = d/t
25 m/s = d/10 sec
D = 25m/s * 10 sec
D = 250 meters
1 min = 60 sec
S = d/t
25 m/s = d/60 sec
D = 25 m/s * 60 sec
D = 1500 m
Remember:“per’ means “every”So, 45 miles per hour is saying that something moves a distance of 45 miles EVERY hour
(distance/time)
2.3 VelocityVelocity is a “vector quantity”–this means is has
Speed and Direction.
If a car travels at 60 km/h we have defined its speed, but if we say it is traveling at 60 km/h heading north we have defined its Velocity!
2.3Going in a straight line at the same speed is called Constant
Velocity.
But if we change our speed (brake at a light) and/or our direction (turn a corner) then we have a Changing Velocity.
If we change our speed by going faster –we call this Acceleration
2.3 VelocityVelocity is speed with direction.
Constant velocity is remaining the same or CONSTANT speed AND direction.
Changing velocity is NOT remaining the same speed AND/OR direction.
2.4 AccelerationAcceleration is changing velocity; either speeding up
or slowing down. Amazing!!!ACCELERATION IS NOT VELOCITY
change of velocity
Acceleration = time interval
2.4When we accelerate in a car from stop to 60km/h in 5
seconds. We have changed our speed and this is Acceleration.
The same applies when we are in a car that slows –this is called negative acceleration or Deceleration.
2.4Acceleration also applies to changes in direction. We
feel the effects when in a car we are pushed to the side when we turn a sharp corner. Blue Angels
If a = Δv/Δt, then this is measured in units km/hr/s or more commonly m/s2
A plane travels from 0 mps to 60 mps in 6 seconds. What is its acceleration?
Answer:
Change in velocity= ending velocity - beginning velocity
Change in velocity = 60 m/s – 0 m/s = 60 m/s
60 m/s (change in velocity) / 6
second (time interval)
60 m/s / 6sec = 10 m/second/second OR
10 m/second2
2.5 Free Fall: How FastWhy does an object fall to the ground when
dropped?
GRAVITY
Gravity pulls objects towards the Earth at an acceleration rate of 10 meters/sec/sec.
2.5If a rock is dropped off the
side of a cliff we would expect it to fall and during the fall we would expect it to accelerate.
If there was no air resistance its speed would increase by approximately 10m/s every second. So after 5 seconds its speed would be 50m/s
2.5If the rock was thrown up
into the air we would still see the rate of velocity change as 10m/s2.
But for the first few seconds it would be decelerating, then stopped for a fraction of a second, before it started its acceleration toward the ground
2.5If we are on a cliff on the Moon, therefore there is no
atmosphere –a vacuum and we dropped a feather and the rock at the same time, they would fall together with the same acceleration.
Of course when on earth where we have air things change because of air resistance. Would you rather jump out of a plane with a parachute or not
and why?
2.5 Free Fall: How Fast Elapsed time – the time that has passed
since the beginning of the fall.
In free fall, an object accelerates at a rate of 10 m per second every second
2.5 Free Fall: How FastTo calculate velocity in free fall:
velocity = acceleration X time
or
v=gt
Remember: g= acceleration due to gravity
Elephant VS Feather
With no other resistance, they both fall with the
SAME ACCELERATION:
10 m/sec/sec
But we all know the elephant would land first. Why?Answer:
AIR RESISTANCE
Air resistance alters the motion of falling objects by adding additional forces.
2.7 Graphs of MotionEquations and tables are not the only way to describe
relationships such as velocity and acceleration.
2.7You can graph the relationships of both time and speed and time and distance by using x and y values.
What is the slope on a distance vs. time graph = to? Slope = rise/run
Slope = Δy/Δx
Slope = distance/time
Slope = speed
What is the slope on a distance vs. time graph = to? Slope = rise/run
Slope = Δy/Δx
Slope = velocity/time
Slope = acceleration
Chapter 2Know the difference between speed, velocity
and acceleration
Know how to calculate the velocity and distance of an object in free fall
Know what “g” is
Chapter 2 Terms:
Acceleration RateAverage speed RelativeElapsed time SpeedFree fall VelocityInstantaneous Speed