CANOPY SPECIFICATIONS The canopy is composed of 5’x2’ modules that attach together on the 5’ side. Multiple sections are placed side by side to cover the width and as many modules per section to cover the length of the space. Standard Extrusion (profile) width 60.75" also available in 121.5" length and can be cut to any length in between. Panel width: To match Extrusion Panel length: Flat 24", Bellowed 22” -23" Vertical length from cable to bottom of canopy when closed 12" Vertical length from cable to bottom of canopy when open 8" Example one section of 5’ wide with 6 panels Flat Length: 144” Bellowed Length: 132” -138” Width: 60” - 60.75” / Section. Total 120”-121.5” Canopy Weight: 23 lbs. / System Total Canopy Weight: (23 x 2) 46 lbs. Minimum required gap between sections, 0.5” Weight: 23 lbs. Minimum required gap between sections, 0.5” Includes: 6 Fabric Panels (Mesh or Canvas) 7 Profiles 14 End Caps 16 Hook and Base Pairs 1 Turnbuckles 1 Cable Wire 4 Eye Screw 1 Roll of Limit Tape (27’) PARTS SPECIFICATIONS Extrusion (Profile) L. 60”- 60 .75” 1 lb. 5 oz. 6063T Anodized Aluminum Shade Panel L. 24” W. 60” - 60. 75“ 1 lb. 5 oz. Phifertex Mesh or Sunbrella Solution Died Acrylic Hook and Base Pair * 3.7 oz. AISI316 Stainless Steel End Cap * 0.2 oz. Plastic with Stainless Steel Screw Limit Tape L. 27’ 100% Polypropylene 1X19 Aircraft Cable D. 1/8” AISI316 Stainless Steel Eye Screw AISI316 Stainless Steel Turnbuckle Open Length 19” AISI316 Stainless Steel Turnbuckle Closed Length 12” Turnbuckle maximum load: 3000 lbs. Recommended Cable Support sizes Up to 20' projection 1/8" stainless steel cable 1x19 construction 21'-40' projection 5/32" stainless steel cable 1x19 cons truction 41' and longer 1/4" stainless steel cable 1x19 construction (subject to engineering approval) Turnbuckle to match cable size