2008 Setra S417

BTC Inc. Installation Spec

Aaccess the fuse panel for various

interior accessories. Some of these

are true ignition; which ones exactly

may vary between models, so use a

DMM to verify.

- Open up the glove compartment

in the middle of the dash.

- Remove the tray liner (clips)

- Test fuses, and remove related

banks. (Two T10 screws for each

bank)

- Ground on painted chassis

- Mount on wooden surface to the

right (This is just a trash can)

DO NOT TOUCH ANY WIRES

THAT EVER SHOW ANY

VOLTAGES BETWEEN 0.1V-5V.

There is a very elaborate

computer system, and almost

every wire in the vehicle is

used for diagnostics and

communication based on

resistances and voltage. Even

the slightest draw could cost

upwards of $10k in damages.

The area shown in the

pictures is safe, and is 24V. If

12V is needed, it can be

found in the exterior

compartment under the

driver seat - on a fuse panel

mounted towards the rear of

the vehicle (the furthest right

thing, if you are looking at it).