boat-lift design and analysis - western michigan university
TRANSCRIPT
BOAT-LIFT DESIGN AND ANALYSISBY: NATHAN SCHICK & JACOB TUSSEY
FACULTY MENTOR: DR. JAVIER MONTEFORT
INDUSTRY MENTOR: JIM TUSSEY
INTRODUCTION
• “Great Lakes Lift”
• Located in Caro, Michigan
• Boat-lifts and docks
• Boat-Lifts
• Range in size (up to 6000 lb.)
• Lifts boat out of water
• Permanently placed in water
OBJECTIVE
• There has never been any
simulations peformed
• Simulate current 6000 lb. lift
• Find potential trouble areas
• High deflection and/or stress
• Low factor of safety
• Theoretically modify and simulate possible changes
• Improve quality of lift
• Give final recommendations based on data
INITIAL DESIGN – CONCLUSION
• Maximum Deflection of 0.43846 inches
• Maximum Stress of 15880 psi
• Safety Factor of 2.5216
INITIAL MODIFICATION PROPOSALS
Proposal 1 Proposal 2 Proposal 3 Proposal 4
Proposal 5 Proposal 6 Proposal 7
INITIAL MODIFICATION PROPOSALS
Proposal 8 Proposal 9 Proposal 10
Proposal 11 Proposal 12 Proposal 13 Proposal 14
REFERENCES
• Abood, A. N., Saleh, A. H., & Abdullah, Z. W. (2013, January 30). Effect of Heat Treatment
on Strain Life of Aluminum Alloy 6061. Retrieved Sept. & oct., 2017, from
http://www.ccsenet.org/journal/index.php/jmsr/article/viewFile/20691/15455
• ASM Aerospace Specification Metals Inc. (n.d.). Retrieved Sept. & oct., 2017, from
http://asm.matweb.com/search/SpecificMaterial.asp?bassnum=ma6061t6
• Gleinco Inc. (n.d.). 6061-T6 Aluminum. Retrieved Sept. & oct., 2017, from
http://www2.glemco.com/pdf/NEW_MARTERIAL_LIST/Alumina%206061-T6.pdf
• Venkateshwarlu, G., & Ramesh Kumar, K. (2014, February 01). Evaluation of Mechanical
Properties of Aluminium Alloy AA 6061(HE-20). Retrieved Sept. & oct., 2017, from
http://inpressco.com/wp-content/uploads/2014/02/Paper53295-297.pdf