Bloch Wall Generator

on: February 05, 2009, 11:05:01 PM

I ran across a really obscure website a really long time ago that featured an inventor who had built a number of overunity generators that

were quite small and output power in the 10-50 kW range (maybe > 100 kW, it was a long time ago). They were dead simple, and I don't

remember ever hearing a word about them anywhere else. The website was very obscure and almost completely all images and I haven't

been able to ever find it again. The inventor claimed interest by several governments, but that is all I remember about the facts surrounding

it. However, I do remember the device design.

The idea is simple. He had a rotor with axial magnets that he spun with a small high-rpm drive motor. He had additional magnets

positioned perpendicularly to the the rotor magnets such that the rotor magnets passed by the armature magnets through their Bloch walls

(the middle of a magnet, basically). Because the rotor magnets passed by the armature magnets through their Bloch walls, he found that

there was no significant drag on the rotor, and it could be kept at a very high rpm (6000-7000?) with very little input power.

The armature magnets, however were significantly affected by the flux of the rotor magnets, and he was able to remove very significant

amounts of power from windings on each end of the armature magnets. I believe he said that he used 8 or 10 gauge wire for the output coil

on the armature magnets and this allowed for outputs of somewhere around 50 kW with 8 armature magnets (16 output coils). I also believe

that he was using low field strength magnets like Alnico or ferrites.

If this design is valid, then it is one of the easiest and simplest ways to realize very significant overunity power production. I have attached

a diagram of what I remember. I would appreciate your feedback and consideration.

bloch wall generator.jpg (25.88 KB, 296x196 - viewed 4816 times.)

Bloch Wall Generator http://www.overunity.com/index.php?topic=6759.0

1 of 1 7/14/2011 1:38 PM