BIG SKY TOWER 60D - 6FT X 14FT (NON-BACKLIT)

Page 1 of 1

3. Locate the Bottom and Side Extrusions:

4. Locate the Top and Side Extrusions:

1. Attach Split Connectors to Side Extrusions:

a. Remove the screw and insert split connectorinto one end of the extrusion. Match like colorednumbers together. (e.g. 3 -3, 4 -4).

b. Tighten screw to lock it into place. Removethe remaining screw from the connector.

c. Then slide the other extrusion onto splitconnector. Make sure extrusions are flushand tighten the screw to secure connection.

c. Connect horizontal extrusion tothe bottom of a vertical extrusion,screw facing inward.

d. Connect bottom extrusions to-gether and use torx key to tighten.

a. See colored numbers on eachextrusion piece. Match like colorednumbers together. (e.g. 3 -3, 4 -4).

a. See colored numbers on eachextrusion piece. Match like colorednumbers together. (e.g. 3 -3, 4 -4).

b. End Lock is already attached toopposite ends of extrusion.

c. Connect horizontal extrusionto the top of a vertical extrusion,screw facing inward.

d. Connect the top extrusions to-gether and use torx key to tighten.

b. End Lock is already attached toopposite ends of extrusion.

SET UP INSTRUCTIONS 1/2

2. Attach Split Connectors to Bottom & Top Horizontal Extrusions:

a. Split Connector: Remove the screwand insert split connector into one endof the extrusion.

b. Tighten screw to lock it into place. Removethe remaining screw from the connector.

c. Then slide the other extrusion onto splitconnector. Make sure extrusions are flushand tighten the screw to secure connection.

BIG SKY TOWER 60D - 6FT X 14FT (NON-BACKLIT)

Page 2 of 2

SET UP INSTRUCTIONS 2/2

a. End Lock is already attached to oppositeends of Support Strut.

b. Align Support Struts within markedlines, and insert End Lock into top andbottom grooves of frame.

c. Add a second support strut to alignmarked lines and tighten screws with torxkey to secure connection.

6. Attach Support Strut to Frame:

b. Insert Center Connector and align holeswith holes on extrusion.

a. Remove screws from Center Connector. c. Repeat to connect other extrusion to makeone long piece.

5. Build Support Struts:

BIG SKY TOWER 60D - 6FT X 14FT (NON-BACKLIT)