big al trading
TRANSCRIPT
![Page 1: Big al trading](https://reader036.vdocuments.us/reader036/viewer/2022062523/58f149ae1a28ab6f198b4627/html5/thumbnails/1.jpg)
![Page 2: Big al trading](https://reader036.vdocuments.us/reader036/viewer/2022062523/58f149ae1a28ab6f198b4627/html5/thumbnails/2.jpg)
D.I.Y KIT
GARAGE DOOR FLOOR SEAL
![Page 3: Big al trading](https://reader036.vdocuments.us/reader036/viewer/2022062523/58f149ae1a28ab6f198b4627/html5/thumbnails/3.jpg)
Stops water and dust from blowing under your garage
doorWe all know that its very difficult to get a garaged floor level , and that leads to water
coming in under the door, dust blows in and it is a endless battle to keep the floor clean, dry and safe.
![Page 4: Big al trading](https://reader036.vdocuments.us/reader036/viewer/2022062523/58f149ae1a28ab6f198b4627/html5/thumbnails/4.jpg)
The garage door seal comes in three sizes:2,6 m Single Garage door and 5,1 Double Garage door
PM on request
2.6 Single Garage door 5.1 Double Garage door
Normally: A single garage door standard size is 2.5m and a double garage is 5mAs a precautionary measure we included a 100mm extra on each strip, just incase the garage door is not 100 % standard
![Page 5: Big al trading](https://reader036.vdocuments.us/reader036/viewer/2022062523/58f149ae1a28ab6f198b4627/html5/thumbnails/5.jpg)
Installation is Easy
![Page 6: Big al trading](https://reader036.vdocuments.us/reader036/viewer/2022062523/58f149ae1a28ab6f198b4627/html5/thumbnails/6.jpg)
All you need
![Page 7: Big al trading](https://reader036.vdocuments.us/reader036/viewer/2022062523/58f149ae1a28ab6f198b4627/html5/thumbnails/7.jpg)
1. DIY KIT2. Benzene Thinners or same as
3. Marking Pencil4. Masking Tape5. Hair Dryer or Heat Gun6. Silicon / Glue Gun7. Old Cloth
![Page 8: Big al trading](https://reader036.vdocuments.us/reader036/viewer/2022062523/58f149ae1a28ab6f198b4627/html5/thumbnails/8.jpg)
This is not always the case, but if the strip has a crinkle cut look you need to do this
The rolled up floor seal may have a memory, roll it out flat ON CLEAN SURFACE heat
gradually with a hairdryer or heat gun, until it is completely flat.
Allow to cool.(a roller may be used to roll the raised edges while heating with a hairdryer, ensure not to overheat the strip)
![Page 9: Big al trading](https://reader036.vdocuments.us/reader036/viewer/2022062523/58f149ae1a28ab6f198b4627/html5/thumbnails/9.jpg)
Measure the strip on either ends of the door, Mark the Strip, then cut to fit.
NB: Do Not cut to much off
![Page 10: Big al trading](https://reader036.vdocuments.us/reader036/viewer/2022062523/58f149ae1a28ab6f198b4627/html5/thumbnails/10.jpg)
Close the garage door. Push the door seal under the garage door from the inside so the door seal ridge is up against the back of the garage door.
![Page 11: Big al trading](https://reader036.vdocuments.us/reader036/viewer/2022062523/58f149ae1a28ab6f198b4627/html5/thumbnails/11.jpg)
Using a soft pencil, mark the floor on both sides of the floor seal so that when you remove it you know where to stick the masking tape.
![Page 12: Big al trading](https://reader036.vdocuments.us/reader036/viewer/2022062523/58f149ae1a28ab6f198b4627/html5/thumbnails/12.jpg)
Place masking tape on either sideof pencil lines. So you have guide lines for when applying the adhesive.
![Page 13: Big al trading](https://reader036.vdocuments.us/reader036/viewer/2022062523/58f149ae1a28ab6f198b4627/html5/thumbnails/13.jpg)
Clean and dry the area where you plan to install the door seal.
All dirt, water, mud, oil and other debris must be removed. Wiping the area with benzene or alcohol will ensure a clean bonding surface.
NB! Use personal protective equipment when using chemicals i.e. gloves, mask, glasses etc.
![Page 14: Big al trading](https://reader036.vdocuments.us/reader036/viewer/2022062523/58f149ae1a28ab6f198b4627/html5/thumbnails/14.jpg)
Apply the adhesive to the floor between the lines, in eitherstraight or zigzag.
![Page 15: Big al trading](https://reader036.vdocuments.us/reader036/viewer/2022062523/58f149ae1a28ab6f198b4627/html5/thumbnails/15.jpg)
This step is very important
Press the strip onto the adhesive starting at one end, slowly forcing out air bubbles as you press the strip down, get someone to hold the long piece up away from the adhesive.
![Page 16: Big al trading](https://reader036.vdocuments.us/reader036/viewer/2022062523/58f149ae1a28ab6f198b4627/html5/thumbnails/16.jpg)
Run a bead of adhesive along the edge of the door seal. Use your finger or a cloth with soapy water so you can smooth out the adhesive before it starts setting. (add adhesive on sides if its needed to ensure sides have been sealed)
![Page 17: Big al trading](https://reader036.vdocuments.us/reader036/viewer/2022062523/58f149ae1a28ab6f198b4627/html5/thumbnails/17.jpg)
Remove the masking tape before the adhesive sets.
![Page 18: Big al trading](https://reader036.vdocuments.us/reader036/viewer/2022062523/58f149ae1a28ab6f198b4627/html5/thumbnails/18.jpg)
FINAL LOOK
![Page 19: Big al trading](https://reader036.vdocuments.us/reader036/viewer/2022062523/58f149ae1a28ab6f198b4627/html5/thumbnails/19.jpg)
View from the inside
![Page 20: Big al trading](https://reader036.vdocuments.us/reader036/viewer/2022062523/58f149ae1a28ab6f198b4627/html5/thumbnails/20.jpg)
As easy as that!!!NB! Don’t drive over the strip for 24 hours
This is truly an
amazing product, and will make your life easier
![Page 21: Big al trading](https://reader036.vdocuments.us/reader036/viewer/2022062523/58f149ae1a28ab6f198b4627/html5/thumbnails/21.jpg)
Unit 5 GPRS Industrial Park Old Main Road Park Ryne Po Box 2065Clansthal4170
Cell : 084 945 5423
Tel : 039 976 1271Fax : 086 652 6215
Email [email protected] Web www.bigaltrading.co.za
Contact details: