belt sander belt tracking if the sanding belt starts to move over to the edge of the sanding...
TRANSCRIPT
Sanders and
Sanding Safety
Belt Sander
Belt TrackingIf the sanding belt starts to move over to the edge of the sanding surface, turn the sander off and contact your teacher.
Belt Sander On and Off Switch
On and Off Switch
Vacuum System
To use the belt sander, the vacuum system has to be turned on.At the end of class make sure the vacuum system is turned off.
Belt Sander Safety
When turning the Belt Sander on and off, make sure to keep your hair and clothing away from the sanding surface.
Jewelry can be a big problem.
Using the Belt Sander
Correct Incorrect
Always keep your work piece flat on the sanding table.
The sanding belt will grab the edge of the work piece and pull your hand onto the sanding surface.
Clean Up
Sweep these areas off with a hand broom from the top down. Use a big broom to sweep the floor.
Disc Sander
On and Off Switch
Disc Sander On and Off Switch
Vacuum System
To use the Disc sander, the vacuum system has to be turned on.At the end of class make sure the vacuum system is turned off.
Using the Disc SanderThe Disc Sander turns clockwise. Sand on the right side of the sanding surface.
Sanding Area
Using The Disc Sander
Always keep your work piece flat on the sanding table.
Correct Incorrect
The sanding Disc will grab the edge of the work piece and pull your hand onto the sanding surface
Stopping the Disc SanderWhen the Disc Sander is turned off, the sanding disc will keep spinning for about 10 min.At the end of class the sanding Disc needs to be stopped for cleaning. Use the wood from the shelf below to stop the sanding disc. Push the edge of the wood on the edge of the sanding disc softly to stop the sanding disk
Cleaning the Disc Sander
Areas to clean with the hand brooms. Clean from the top down.
Using Sanders Video
Oscillating Sanders
On and off switches
How to sand
Always keep your work piece flat on the sanding table.
Correct Incorrect
The sanding Disc will grab the edge of the work piece and pull your hand onto the sanding surface
Using A Oscillating SanderKeep work piece flat on the sanding table
The sanding tube spins. Work in the opposite direction the sanding tube is spinning
Cleaning The Oscillating Sander
Using a hand broom to sweep the sanding table. The sides of the sander. The table the sanders are on, and the floor around the table.
The sawdust from the sanders are very fine and light. Never blow the sawdust.
Hand sander
Power Switch Lock
Power Switch
To keep the hand sander running with out holding the power switch, hold the power switch on and push the power switch lock in, then release the power switch
Using the Hand Sander
Sanding Surface.Never Touch the sanding surface while the sander is on
Cleaning the Hand Sander
Use a hand broom to sweep the table top, the sander and the floor under the sander. Sweep from the top down.
Watch where your head is when sweeping the floor under the sander.
Hand Sanding
When using sand paper, make sure to keep your knuckle away from the surface.
Sweep the table top with a hand broom