bavi
TRANSCRIPT
2
S.No Topic Page No
1 Antenna Parameters 2-6
2 Hct & Vct 7
3 RF Clamp 8
4 Roxtec 9
5 Earthing Kit 10
6 Lugs 11
7 Jumper Cable 12
8 Routing Of Cables 13
9 Surge Arrestor 14
10 Weather Proofing KIt 15
11 Cable Tie 16
12 Labeling 17
13 Grounding 18
INDEX
3
Height Of Antenna-
• Height Of Antenna Should Be
According To RF Plan
• Height Of Antenna Must taken
From The Ground
5
Azimuth Angle Of Antenna-• It is the angle of an object with respect to North
Direction in clockwise direction
6
Carrier Configuration Of Antenna-
• Carrier Configuration Should Be Acc. To Plan• It Decide The Number Of Trx In Each Sector
Types Of Antenna-
• Antenna Should Be According To The RF Plan For Each Sector
8
RF Clamp-
• RF Clamp should Used to tight the feeder cables• Distance Between Two Rf Clamp On Vct should
Be 1 To 1.5m• Distance Between Two Rf Clamp On hct Should
Be 0.6 To 0.9m
10
EARTHING KITS-
• Earthing Kit Should Terminated With Either Tower And EGB• Both Lugs and Cable Should Be Of Same Material And Same Size• Position Of Earthing Kit Should 1 To 1.5m Away From Outdoor
Jumper Cable• Earthing Kit Should Use at Every 30m
11
Lugs-
• Size of lug should be same as the cable• Material of should be same as the cable• Lugs should be properly crimp
12
JUMPER CABLE -
• Jumper Cable Should be 1.5m for indoor & 3m for outdoor.
• It should have 7/8” or 7/16” Male connector
13
ROUTING OF CABLES-
• Feeder cable should be routed on VCT and HCT in a line not zig zag wise
• Bending Radius at VCT and HCT should be more than 300mm
14
Surge Arrestor-
• It Should Connect with Indoor Jumper Cable And Feeder Cable
• It Should Properly Ground With EGB
15
WEATHER PROOFING KIT-
There Should 3 Types Of Layers-• PVC• BUTYL• RUBBER • First And last layer should be of PVC Tape• Last hand of PVC tape Should Be From Bottom To TOP
16
CABLE TIE
• Cable Tie Should be Used to tie the cables• Size of cable tie should be 4”and 6” for Indoor• Size of cable tie should be 10” and12” for
outdoor
17
LABELLING-
• Labeling should be proper for each sector• Transparent tape should be used for
labeling