basic kinesiology taping guide - cheapbowlingballs.com...basic kinesiology taping guide thank you...
TRANSCRIPT
Basic Kinesiology Taping GuideThank you for choosing Genesis® K-Motion™ kinesiology athletic tape, the first tape of its kind with Copper Infuzion™! Please use this guide as a resource to help
you stay active and performing your best. For more helpful tips and product applications, please visit us online at BowlGenesis.com/K-Motion-instructions
Finish up by anchoring the end with 0% stretch, then rub the entire application firmly to fully adhere and activate the adhesive.
Anchor a full strip on skin above “X” pattern, stretch piece to 25%, then lay down over center of “X”, before turning towards the forearm.
Stretch the other half strip 75% and apply vertically over the first piece to make an “X” pattern. Anchor the ends with 0% stretch.
Fold paper backing & apply a 75% stretch horizontally across the point of pain. Press down the ends with 0% stretch.
Position your arm at a 90° angle in front of your body while having your partner tear the backing in the middle of a half strip.
Position 1 2 3 FinalItems Needed• One 10” Strip• Two 5” Strips• Scissors• Partner
PreparationCut a Full Strip in half to make two 5” Strips. For proper fit, trim length if needed.
Finish up by anchoring the end with 0% stretch, then rub the entire application firmly to fully adhere and activate the adhesive.
Bending hand down, anchor a full strip 1” above the knuckles with 0% stretch. Next, stretch the tape 25% and apply up the top of your arm.
Use the other half strip to apply a 75% stretch across the bottom of wrist. Anchor the ends around with 0% stretch and no overlap.
Tear backing in the middle of a half strip, fold back & apply a 75% stretch across the wrist. Wrap ends with 0% stretch and no overlap.
Hold arm out and away from your body with your hand facing in a downward position.
Position 1 2 3 FinalItems Needed• One 10” Strip• Two 5” Strips• Scissors• Partner
PreparationCut a Full Strip in half to make two 5” Strips. For proper fit, trim length if needed.
Trim excess hairfor better adhesion
Remove tape gently, Do NOT rip off skin!
Apply the proper amount of stretch
Apply 30 minutesprior to activity
Clean area of dirt, lotions and oils
Rub firmly onto skinto activate adhesive
Always anchor ends with NO Stretch
Always round the corners when cutting
Toll Free: 1 (888) 959-6362
insert the application needed from the list below
Finger JamThumbBiceps / TricepsGeneral ElbowGolfers Elbow
Rotator CuffAC JointNeck StrainSpineRib Pain
AbdominalLower BackGroin StrainHip FlexorGluteus Pain
IT BandQuad / ThighShin SplintsCalf Pain / SupportBack / Inner / Outer Knee
Plantar FasciitisAchilles TendonitisBall of FootTurf Toe...and more
Place ankle at 90° on a chair. Stretch a strip 50% and apply from the middle out under the heel. Anchor each end above the ankle.
Anchor 2nd Strip on the inside of your foot with 0% stretch. Apply a 50% stretch and wrap around the back of your heel.
Continuing the 50% stretch, turn tape to wrap under your arch and anchor back near the starting point with 0% stretch.
For the 3rd and final strip, repeat steps 2 & 3, this time starting on the outside part of your foot.Tip: The 2 strips should mirror each other.
Finish up by rubbing the entire application firmly to fully adhere and activate the adhesive.
Items Needed• Three 10” Strips• Partner, if desired
PreparationFor proper fit, trim length if needed.
DISCLAIMER: Discontinue use if product causes redness, soreness or irritation. This product is not intended to replace professional medical treatment. This guide has been provided for educational purposes only. Product warranty covers replacement product or costs only. © 2015 Genesis Bowling. All Rights Reserved. Designed in USA. Made in Korea.
2 3 4 FinalPosition + 1
Bend your knee at a 90° angle while sitting. If you want addt’l support, repeat Step 1 by applying the other half strip over the top.
Stretch a half strip 75%, then apply just below the kneecap, adhering from the middle out. Anchor each end with 0% stretch.
Anchor a full strip to mid-thigh, stretch 25%, and adhere to the side of kneecap. Stretch remainder 50% under and across the knee.
Anchor the piece with 0% stretch, then repeat Steps 2-3 on the other side of your knee, using the remaining full strip.
Finish up by rubbing the entire application firmly to fully adhere and activate the adhesive.
Items Needed• Two 10” Strips• One or Two 5” Strips• Scissors• Partner, if desired
PreparationCut a Full Strip in half to make two 5” Strips. For proper fit, trim length if needed.
Position arm down your side while tilting head slightly forward and away. Keep your arm relaxed.
Anchor “Y” strip 1-2” above elbow with no stretch. Apply a 25% stretch to a “Y” strip tail, and follow shoulder around and up to the top.
Take other “Y” strip tail and do the same around the front of the shoulder, ending with a slight overlap when anchoring on top.
With approx. 2/3 of length towards the back, stretch 2nd strip 50% and adhere to the top of the shoulder, anchoring the forward end first.
Finish by stretching back over the shoulder blade, then anchor. Rub the entire application firmly to fully adhere and activate the adhesive.
Items Needed• One 10” Strip• One 10” Strip, Y cut• Partner
PreparationCut a Full Strip almost half way to make a “Y” Strip. Make sure to round the ends. For proper fit, trim length if needed.
1 2 3 Final
25%
50%
1 2 3 FinalPosition