auto cad_chapter2 draw and modify tools

7/27/2019 Auto CAD_Chapter2 Draw and Modify Tools

1/21

Auto CAD

BY: Engr. Jeffrey C. Odtohan

EcE Department

P.U.P. Sta. Mesa, Manila


2/21

Chapter 2:

Draw and Modify Tools


3/21

The Draw Tools

To start the command Left-clickon the

command in the 2D Draw control panel.

It is good to read the notes in the Command

line in the command window.

Use the Buttons on the Status Barto

smoothen the use of the commands.

To familiarize the draw tools, a sets of

exercises will be given.


4/21

Exercise 1

Instructions: You can use the following commands; line, polyline

and dimension command.


5/21

Exercise 2




6/21

Exercise 3

Instructions: You can use the following commands; line, circle and

dimension command.


7/21

Exercise 4




8/21

Exercise 5




9/21

Exercise 6

Instructions: You can use the following commands; circle and

dimension command.


10/21

Exercise 7

Instructions: You can use the following commands; polyline and

dimension command.


11/21

Exercise 8

Instructions: You can use the following commands; polyline and

dimension command.


12/21

Exercise 9

Instructions: You can use the following commands; line, polyline,

arc, and dimension command.


13/21

Exercise 10

Instructions: You can use the following commands; polygon, circle

and text command.


14/21

The Modify Tools

To start the command Left-clickon the

command in the 2D Draw control panel.

It is good to read the notes in the Command

line in the command window.

Use the Buttons on the Status Barto

smoothen the use of the commands.

To familiarize the draw tools, a sets of

exercises will be given.


15/21

Exercise 11

Instructions: You can use the following commands; line, polyline,copy and dimension command. Complete the figure by using

chamfer and fillet command. Then after use offset inside and

outside by 10.


16/21

Exercise 12

Instructions:

1. Draw the 1st figure using line or polyline command. Please

take note of the dimension.

2. Draw the 2nd figure using mirrorcommand.

3. Move the figure in the location (100,100) with respect to its

reference point indicated by the red arrow. Then check the location.

(100,100)


17/21

Exercise 13

Instructions:

4. Draw the below figures using copy command.5. Erase all the figures copied except to the original figure.

6. Draw again the below figures using the array command.


18/21

Exercise 14 Instructions:

7. Draw the below figures using circle command.8. Move the circle in location (500,100) with respect to its center.

9. Using the offset command, draw the figure below. Outer circle

has an offset of10 while inner circle has an offset of5.


19/21

Exercise 15

Instructions:

10. Draw a line with a dimension of 200 across the center, Refer tothe drawing below.

11. Use the trim command to draw the next figure below.


20/21

Exercise 16

Instructions:12. Use the extend command to draw the next figure below.


21/21

Exercise 17 Instructions:

13. Use the array command.14. Set to polar with center (700,100).

auto cad_chapter2 draw and modify tools

Documents