audi r8 spyder - fuel cap 2

Upload: ohshafi

Post on 01-Jun-2018

238 views

Category:

Documents


0 download

TRANSCRIPT

  • 8/9/2019 Audi R8 Spyder - Fuel Cap 2

    1/4

    Removing and installing rear side panel (top) with tank flap unit

    Removing

    Remove rear side panel (bottom) Chapter.

    Remove side panel trim Chapter.

    Remove secondary air pump motor -!"!- Rep. gr.#$.

    Remove tail light %lectricalsystem& Rep. gr.'.

    ake electrical connector -!- out of

    bracket and move wiring harness -#-clear.

    Remove bolts -arrows-.

    *ote

    +pen tank flap and detach cap from fuelfiller neck.

    ,isengage loop -!- of manual releasecable at rear cross member.

    ove clear manual release cable -#-.

    nplug electrical connector -/-.

    ,isregard -item - and -arrow-.

    0age ! of Removing and installing rear side panel (top) with tank flap unit

    #"1"!1#"!2vw-wi311rl14.en-56.4"".2R7".!.wi332"$'""/$.8ml98sl:/

  • 8/9/2019 Audi R8 Spyder - Fuel Cap 2

    2/4

    Remove bolts -arrows-.

    Detach rear side panel (top) -1- and guideout drain hose for fuel filler neckupwards.

    Screw filler cap back onto fuel filler

    neck.

    age ! of "Removing and installing rear side panel (top) with tank flap unit

    !#$#1$!#1%vw-wi&$$rl$'.en-.'##.%R*#.1".wi&&%#+,##+.ml/sl0

  • 8/9/2019 Audi R8 Spyder - Fuel Cap 2

    3/4

    Note

    Installing

    l Gap widths Chapter

    l Tightening torques Chapter

    Install in reverse order of removal; note thefollowing:

    Check freedom of movement of adusternut !"! of aduster element !arrows!#

    Completel$ screw down aduster nut% &utdo not tighten#

    Insert rear side panel 'top(#

    Tighten &olts#

    )hen tightening the &olts% the nuts of theadusters automaticall$ turn towards themounting point on the rear side panel 'top(to lock it in place#

    Install manual release ca&le Chapter#

    )*+NING

    ,age - of .+emoving and installing rear side panel 'top( with tank flap unit

    /010"1/0"2vw!wi:11rl1*#en!G3#*00#2+40#".#wi::205600-5#7ml87sl9-

  • 8/9/2019 Audi R8 Spyder - Fuel Cap 2

    4/4

    +isk of fire#

    tThe drain hose for the fuel filler neckmust &e routed as it was prior to removalto avoid a risk of fire#

    tInstall drain hose for fuel filler neck Chapter#

    Install rear side panel '&ottom( Chapter#

    Install side panel trim Chapter#

    Install tail light lectricals$stem; +ep# gr#6.#

    Install secondar$ air pump motor !"0"! +ep# gr#/5#

    ,age . of .+emoving and installing rear side panel 'top( with tank flap unit

    /010"1/0"2vw wi:11rl1* en G3 *00 2+40 ". wi::205600-5 7ml87sl9-