aristarco ap 50.32 simplified operating instructions
TRANSCRIPT
Cycle switchMain power switchDrain switchWater softener switch
Salt containerWash pump filterCombined wash and rinse armDrain plug hole
Drain plugDrain filter
Cycle lightPower lightReady lightWater softener light
To switch the machine on· Fit drain filter and drain plug into drain plug hole· Close the dishwasher door· Switch on the main power switch, the dishwasher will now fill
and heat. The dishwasher is ready to use when the ready light is illuminated.
· Press the cycle switch for 2 seconds, the cycle light will illumi-nate, after the cycle light goes out the cycle is complete.
To drain the dishwasher· Switch of the main power switch· Remove the drain plug LEAVE THE DRAIN FILTER IN
PLACE.· Press the white drain switch for 2 seconds, the drain pump will
run for 2 minutes to drain the machine.· Clean out the dishwasher including the drain filter.
Water softener regeneration· With the dishwasher drained and clean remove the salt container
lid· Pour in 1 mug full of dishwasher salt and replace lid.· Close the dishwasher door· With the main power switch off, press and hold the water sof-
tener switch for 3 seconds, the water softener will then go through a regeneration cycle, this is indicated by the water sof-tener light illuminating. This will take 20 minutes.
· THE WATER SOFTENER MUST BE REGENERATED EVERY DAY.