8/10/2019 APG43 LMT Access Procedure

1/7

APG43 Components: GEP/APUB

Two SAS connections to the two GED/Diskboards.

Single SATA connection to the GED/DVDboard.

SATA/USB connection to the Alarm board.

Local ethernet port.

Two public ethernet ports.

Serial console port.

Boots from system disk, flash disk or USB.

GEP - APUB

S

AS-1

SAS-0

SATA-1, USB-0

ETH-1

ETH-0

USB-1

SATA-0

ETH-2, DEBUG

CONSOLE

RESET

POW

MIASNC

POW = POWer on

SNC = System Not Connected

MIA = Manual Intervention Allowed

Front connectors:

8/10/2019 APG43 LMT Access Procedure

2/7

Local Operation and Maintenance: HyperTerminal Via the console connector on the GEP boards. This

connection is intended for emergency use only

Following parameters need to be set: - Connect using: Theconnected COM-connector (usually COM1 or COM2)- Bits per second: 57600- Data bits: 8- Parity: None

- Stop bits: 1- Flow Control: None

Press Enter, now the prompt "SAC>" should be seen.

Remote Operation and Maintenance Same as APG40 (telnet, SSH, FTP, SFTP).

How to access APG43:ETH-2, DEBUG use a common procedure Eth local IP teminal 192.168.200.x

need Ethernet cable RJ45/priopreatary connector

Console Port Serial cableneed Serial cable 9 pin/proprietary connector

8/10/2019 APG43 LMT Access Procedure

3/7

LCT

8/10/2019 APG43 LMT Access Procedure

4/7

8/10/2019 APG43 LMT Access Procedure

5/7

WinFiol

8/10/2019 APG43 LMT Access Procedure

6/7

CHA Command Handling (OSS RC)

8/10/2019 APG43 LMT Access Procedure

7/7

FTP