8/8/2019 Apache 2,3,4.Pdf4ba7b60f9c164

1/1

IF YOU HAVE ANY PROBLEMS PLEASE CONTACT YOUR LOCAL RETAILER orAMG Group Ltd., Kelburn Business Park, Port Glasgow, Scotland, PA14 6TD

UK Consumer Hotline: 09018 140 020 E-Mail: info@lichfield.co.uk Telephone calls to this number will be charged at 25p per minute. Call charges from mobiles may vary.

Pitching Instructions - Apache 2 , 3, 4

INNER PITCHING FIRST FLYSHEET

Assemble the poles and lay them on theground. (3 poles: 2 longer diagonalpoles and 1 shorter porch pole).

Open out flysheet and position so thatthe inner doorway and the flysheetdoorway correspond.

Open out the inner tent and position inthe required direction. The poles arecolour coded to matchcorresponding pole sleeve entrypoints.

Pull flysheet over the inner tent andposition seams to correspond with poleson inner.

A number of fabric ties are located onthe underside of the flysheet. These

Insert the two longer poles through thepole sleeves running diagonally acrossthe inner. The poles will need to be fedthrough the short sections of pole sleeveat the top of the inner tent.

must be secured, by use of a simplebow, to the exposed poles of theinner tent.

Peg down each side of flysheet throughthe shock-cord pegging points, adjacentto the metal rings of the inner tent. Usethe pin-pegs supplied.

Locate one end of each diagonal poleonto the pin system at the corners of thegroundsheet (see figure 1). Insert remaining porch pole into the pole

sleeve on the outside of flysheet.Push each diagonal pole from theopposite ends into an arch and locatepole ends onto corresponding pinsystem at corners.

Locate one end of pole onto the pin

system. Push the opposite end of the pole intoan arch and locate pole end onto thecorresponding pin system.

Tie inner to poles at roof crossover The inner tent should now be free

standing (reposition if required). Pull porch taut, away from main body oftent and peg down the corners of theporch through the shock-cord peggingpoints using pin-pegs.

Peg the inner tent groundsheet at eachcorner through the metal rings using pin-

e s see fi ure 2 . Peg out all remaining shock-cord

pegging points on the base of theflysheet using pin-pegs.

Peg out ALL guy lines using pin-pegsensuring that guy line fabric attachment

points are evenly tensioned. Open flysheet door and peg front

corners of porch groundsheet. Figure 1. Figure 2.

Ring and Pin System.1. Locate one end of each pole onto the corresponding metal pin. The metal pin inserts into the hollow metal

ferrule on the end of each pole. (See Figure 1). Push the pole into a curve from the opposite side, one at atime, and locate all pole ends onto the metal pins.

2. Peg the corners of the tent through the metal rings using pin-pegs. It is important to drive the peg into theground at a 45 degree angle to obtain the best grip. (See Figure 2).