ap238-ps29/ps31 manual (heat sensitive)
DESCRIPTION
AirPRO 238 Professional Series PS29/PS31 Installation Guide and Users ManualTRANSCRIPT
Installation Guide and Users Manual
Wall Mount Range Hood
AirPRO 238 Professional Series (PS29/PS31)
IMPORTANT:Read and save these instructions.NOTICE:Installer: Leave this guide with the homeownerHomeowner: Keep this guide for future reference
Rev. 3065u.2b
Important Safety NoticeRead all Instructions before Installing and operating this appliance
-
DO NOT
DO NOT -pors.
-
sure to vent air outside. DO NOTor garages.
-den utilities.
vendor.
Important Safety NoticeRead all Instructions before Installing and operating this appliance
WARNING-
-
what can happen if the instructions are not followed.
The manufacturer and/or distributor/reseller declines all responsibility in the event of failure to ob-serve the instructions given here for installation, maintenance and suitable use of the product. The manufacturer and/or distributor/reseller further declines all responsibility for injury due to neg-ligence and the warranty of the unit automatically expires due to improper maintenance.The manufacturer and/or distributor/reseller will not be held responsible for any damages to per-sonal property or real estate or any bodily injuries whether caused directly or indirectly by the range hood.
Table of Contents
INSTALLATIONTools needed....................................................3
USE AND CARE
MAINTENANCE
WARRANTY
Tools needed:
Level
screwdriversscrewdriver or drill
Measuring tape
pencil
Parts supplied:
Range Hood
Venting Requirements Height & Clearance
-tic or other enclosed area.
caps.
aluminum vent is recommended.DO NOT use plastic vent.
-
1. 2. -
tertop/stove (recommend* 27” to 30”).3. Distance between the countertop/stove
4.
hood.
-
hood.
opening around the cap.
-
Upper
Range hood
mounting
Lower
-
IMPORTANT:-
duct.
and caps.
-
Minimum Duct Size:
Duct Run Calculation:
Roof cap
Duct Run Calcuation example:
0ft + 9ft + 9ft + 5ft = 23ft used.
Deduct 23ft from 50ft, 27ft
Calculating Vent System Length
Venting Methods
IMPORTANT:
Roof cap
IMPORTANT:
the ground path is adequate.
of the line.DO NOT ground to a gas pipe.
DO NOT have a fuse in the neutral or ground circuit.
IMPORTANT:
-
Electrical Requirements
Preparation
Range Hood Operations,
Range Hood Operations,
Venting requirements and Electrical requirementsVenting Requirements
wall or roof openings.-
WARNINGSevere Injury
Hood may have very shape edges. Please wear protective gloves if it is necessary to remove any parts for installing, cleaning or servicing.
WARNINGExcessive Weight
Require three or more person to move and install this range hood. Spinal or other bodily
injuries could occur if it is not followed.
WARNINGSevere Injury
Rotating fan can cause severe injury. Stay clear of fan when
motor is running.
Installations :
-
Using references in
and secure it using two mounting screws.
3.
-
Installation
Figure 3
Installation (Continued)
-
-
and
Range Hood Operations
-
-
Increase or Decrease IncreaseIncrease
DecreaseDecrease
Light Decrease
Auto Function
Range Hood Operations (Continued)
Light Decrease
Auto Function
Troubleshooting
-nected.
-
-
3.
-
--
-
NOTE:
Use and Care Information
instructions for future reference.
-
3:
Ampere
Noise Level
Measurements and Diagrams
Installation Overview:D
ation Overview:D
Upper support frame
Range hood
mounting
A
Air
Mov
emen
t Dir
ectio
n
D
Hood-mounting
BD
B
A
range hood
A
All measurements in parenthesis are in millimeter.
Overall:
All measurements in parenthesis are in millimeter.
No. Description No. Description
3
Halogen Light Transformer
MotorHalogen Light
No. Description No. DescriptionMotor
3
No. Description No. Description
3Halogen Light Transformer
WARNINGHazard of Burns!
Light bulb become extremely hot when turned on. DO NOT touch bulb until switched off and cooled.
Touching hot bulbs could cause serious burns.
Maintenance
help preserve the appearance of the range hood.
® ®
® ®
cleaning solution onto or into the control panel. Follow directions of the stainless steel cleaner. CAUTION: Do not
® ®
DO NOT allow deposits to accumulate or remain on the hood.
-
IMPORTANT:
®
-row on the inner ring with the arrow on the outer ring where it
reverse the steps.
-
-
product.
-
TTTTOOOO OOOOBBBBTTTTAAAAIIIINNNN SSSSEEEERRRRVVVVIIIICCCCEEEE UUUUNNNNDDDDEEEERRRR WWWWAAAARRRRRRRRAAAANNNNTTTTYYYY:::YYoYoYouuu mumumuststst pppprereresesesentntnt pppprororo fofofof oooffff orororiigigiggiininin lalalal ppppururur hchchchasasaseee ddadadatetete..
Warranty
-
NO
each individual range hood model.
Contact Us
Disclaimer
Your Notes