analysis steps for abacus static analysis geneva wheel
TRANSCRIPT
-
7/25/2019 Analysis Steps for Abacus static analysis Geneva wheel
1/8
The mesh, material and property is created in hypermesh.
Import the fle to abacus.
Under Module-Property, you can see stell is assigned
Next, goto tools- reerence points. i!e ",#,$ !alues at the bottom as.
%,-&',% and hit enter
(gain gi!e )%.'&*,-&+.',% and hit enter. It ill create reerence points
as shon belo.
reate * sets o elements o both dri!er and dri!en.
oto Interaction manager / create / surace to surace-
-
7/25/2019 Analysis Steps for Abacus static analysis Geneva wheel
2/8
0elect by angle gi!e 1% and select as shon the regions here
interactions happen 2use shit 3ey to select 4 and done. Next clic3 on
sla!e and select the dri!en gear contact regions as shon belo,
(ter that
-
7/25/2019 Analysis Steps for Abacus static analysis Geneva wheel
3/8
ontact interaction property - 5it create- contact-mechanical-
tangential beha!ior- riction ormulation-penalty- ric coe6 7 %.&
-
7/25/2019 Analysis Steps for Abacus static analysis Geneva wheel
4/8
o to constraints / MP constraints- continue / clic3 geometry and pic3
8P& o dri!en
lic3 on mesh / select region or sla!e nodes / indi!idually / 0elect
completely using shit 3ey- 9one
-
7/25/2019 Analysis Steps for Abacus static analysis Geneva wheel
5/8
9o the same ay or dri!er gear.
-
7/25/2019 Analysis Steps for Abacus static analysis Geneva wheel
6/8
:oad- ;oundary condition manager / clic3 geometry, select 8P& and
chec3 U&, U*, U
-
7/25/2019 Analysis Steps for Abacus static analysis Geneva wheel
7/8
9ouble clic3 on propogated in step * and gi!e ).*' radians as shon
Next, Tools- set / manager- create / static general / continue
Nl geom on
hange increment as shon belo
(gain create / static general / step * and repeat till step ).
i!e same initial, min and maximum !alues as shon abo!e or next )
steps.
-
7/25/2019 Analysis Steps for Abacus static analysis Geneva wheel
8/8
o to feld o=p manager in module / step. 0econd option
9ouble clic3 >ust belo step * and select ?orce=displacement rom the
dialogue box. hec3 8?orce and 8M orce and o3.
8un the model