tools you will need #8 torx driver #10 torx driver standard phillips screwdriver small...

Tools you will need

• #8 Torx driver

• #10 Torx driver

• Standard Phillips screwdriver

• Small (jewelers)Phillips screwdriver

• Small standard screwdriver

With the autoloader upside down, remove 4 #10 Torx screws

1

2

3

4

Slide the outer case towards the back of the drive and remove it

Removecase

Turn the autoloader top up and remove 4 Phillips screws (2 on each side) from the inner case

1

2

3 and 4 areon the otherside

Slide the tape and carousel mechanism towards the front of

the drive face about 3 inches

Pushout

Remove data cable and 4 wire connectors from the mechanism

Data cable

4 wire connectors

1

2

3

4

The number one connector can be removed from the top of the drive prying it toward the center of the drive and pulling it out the

back

Remove mech from housing by sliding it out the front

Carouseland tape Drivemechanism

Tape drivehousing

remove

From the back of the drive remove the 2 #8 Torx screws that hold the drive retaining bracket

in place.Retaining bracket

2 #8 Torxscrews

Lift the drive ¼ inch and pull retaining bracket up and out

Retaining bracket

Lift up ¼ “

Continue lifting drive to 60 degree position

Pull drive out and lay upside down on top of carousel

Drive

Auto-loader

You can see the magazine inside the carousel

Magazine

Remove magazine from carousel by lifting up