te-plgter manual · te-plgter manual. 2015-2017 gmc terrian. speed adjustment press and hold the...
Post on 22-Mar-2020
4 Views
Preview:
TRANSCRIPT
07/23/18
TE-PLGTER Manual2015-2017 GMC Terrian
Speed A
djustment
Press and hold the R
ear button until the system
beeps 5 tim
es, then release. 10 quick beeps = fast1 long beep = slow
(default)
1.Cable Connections1.Cable Connections
Buzzer
4 - Not used in
this application
SD
card slot
1234
Connection location
A IBE
AM
Height A
djustment
Adjust the tailgate by hand to the desired
height. Then press and hold the Front button
until the system beeps 2 tim
es, then release. P
erform a key cycle to verify adjustm
ent.
New
rear button
To electronic
locking mechanism
AC
ontrol box side A
1.Cable Connections - contin.
Control box side B
123456
4 - not used in this application
GroundGround
Fuse
CAN box
Power Clam
p - connect at fuse box
To New
Front button
Connect to OBDII
After installation is com
plete, close the tailgate m
anually, slowly, so the system
can initialize.
This system
can operate with the original rem
ote as follows:
•Long press of unlock button
•D
epending on the remote som
e may
be 3 quick presse
2. Installation
1. Remove the top panel from the tailgate.
2. Remove the screw from the handle pocket on the tailgate.
3. Remove the side panels from the tailgate.
4. Unplug the original lock button connector to input our t-harness.
5. Route the lock wiring as shown in the photo.
6. Remove the OE springs and re-install the powered struts. OE mounting and ball joints are re-used.
7. Holes will need to be drilled in the body to run the wiring for the powered struts. The cablingdoes have grommets to provide a water tight seal. Measure out the wiring and grommet and becareful to drill in a safe location away from any other wiring inside the vehicle. ½ inch startinghole is suggested.
8. Above is the mounting location in the tailgate for the brain. It is in the middle of the tailgate. Also find a good location in the tailgate for the buzzer. Buzzer attaches with double side tape. Allwiring will need to be ran to this location through the tailgate and the boot of the tailgate from in the vehicle.
9. Route the wiring for the power through the boot of the tailgate using a threading tool.
10. Run the wiring to the front of the vehicle for the remained of connections.
11. Place the provided t-harness in-line with the current t-harness.
12. Use the provided power clamp the clamp onto power at the fuse box. Assemble the clamp asshown in the picture around the power wire.
13. Use the provided hole saw to drill a hole for the front button and mount it using the providedhardware.
14. Use the provided hole saw to drill a hole for the rear button and mount it using the providedhardware.
15. Before re-assembly, test for proper function.16. Re-assemble vehicle.
top related