smart fortwo body kit w450
Post on 11-Sep-2014
715 Views
Preview:
DESCRIPTION
TRANSCRIPT
IINSTALLATION MANUAL:NSTALLATION MANUAL:Body Kit Set for Smart Fortwo W450 from 04/2002
Firstly, we remove the current front-spoiler.We place the brand new front-spoiler by screwing the 3 screws (T20) under the Registration No. and then we are screwing 2 screws (T10) on the left and the right side of the front-spoiler. We place the 2 metal brackets under the spoiler and inorder to stabile the front-spoiler We stabilize the front spoiler by screwing the 6 screws (3 on each one) on the soil protection, see photo.
Frontspoiler for Smart Fortwo W450 from 04/2002
Tools:Drill, Torxscrewdriver 2x (T10, T20)
Content:Frontspoiler, screws 11 pcs.,2 x Metal brackets
www.smart-power-design.com
IINSTALLATION MANUAL:NSTALLATION MANUAL:Body Kit Set for Smart Fortwo W450 from 04/2002
We campaigning lighter side, we need to expand the tworear wheels. Let us take the side sills and up on the inside, we sat down at some points (8 to 10) thenecessary silicon.We put the sills on the right place to expand without theoriginal, and we attach the two screws back and theother two in front, see photo 1 and 2.
Side skirts for Smart Fortwo W450 for all Cabriosand for Coupes from 04/2002
Tools:Electric screwdriver,Torx screwdriver,Paper adhesive tape, clean cloth and detergent
Content:Side skirts 2 pcs.,Screws 8 pcs.
www.smart-power-design.com
IINSTALLATION MANUAL:NSTALLATION MANUAL:Body Kit Set for Smart Fortwo W450 from 04/2002
Then we glued paper tape with the sills of the lower floorto the door, the side skirts that sit right on the page. he tape can be removed after 24 hours.
Photo 1
Photo 2
www.smart-power-design.com
IINSTALLATION: NSTALLATION: Body Kit Set for Smart Fortwo W450 from 04/2002
Firstly, we remove the whole rear spoiler with thefender. Then we replace the old rear bumper with thenew rear panel and screw it with 7 screws. . After thatwe place the rest rear spoiler.Then, we fix the rearspoiler with the small curved plates to its basis (seephoto) which is now attached in the same place wherethe original was attached.In the end, we pull the rear panel back until we get adistance of 4cm from the exhaust, to prevent the spoilergetting hot from the exhaust.
Note:For the exhaust comes out in the middle, you must cut first the middle part
Rear panel for Smart Fortwo W450 for all Cabriosand Coupes
Tools:TorxscrewdriverDrill
Content:Rear panel, screws 9 pcs.,rosettes 2 pcs., small curved plate 2 pcs.
www.smart-power-design.com
top related