quick start guide: product setup€¦ · plug power and load cell cables into the adapter module....

ADAPTER MODULE LOAD CELL CONNECTOR CONFIGURATIONS

QUICK START GUIDE

#XXXX-XXX

QUICK START GUIDE:

Quick Start Guide POINT Unit

PACKAGE CONTENTS

1 2

2

Adapter Module 3

TOOLS REQUIRED

#4 Phillips Screwdriver Android 5.0 or iOS 10.0 Device 1

*NOTE

Internet connectivity to Android or iOS device is required for initial set up. However, internet service (Cellular data/WiFi) is not needed to function in the field.

PRODUCT SETUP

ASSEMBLE UNITS

Remove both the POINT unit andadapter module from packaging.Slide the adapter module into therails located on the back and bottomof the POINT unit.

When the adapter is flush and in place, use a #4 Phillips screwdriver and tighten the 4 captive screws.

1 2

1

2 MOUNTING OPTIONS

The POINT unit mounts to three different systems: Rail Mount, V-Plate Mount & Ram Mount. Refer to the illustration below that matches the mount you have.

Rail Mount1

Ram Mount3

V-Plate Mount2

To mount the Ram Mount, remove the hardware from the Rail Mount and secure the Ram Mount to the rear of the enclosure.

*NOTE

APP DOWNLOAD

Your mobile device must be connected to the internet to complete this step. Download the Scale-Tec POINT mobile app. Register and log into the app.

4

CABLE CONNECTIONSPlug power and load cell cables into the Adapter Module. Refer to the connector cable that matches your specific adapter module (as indicated on packaging). Do not turn on the unit until you have completed Step 4.

3

Power Load Cell

Auxiliary Port

Power Cable

Load Cell

Cable

AMP

M12 CROWN

DT6

TURN ONPress the power button topower on the device.

BASIC INDICATOR OVERVIEW

Press to power on. Press and hold for 3 seconds to power off.

Press and hold for 3 seconds to zero the scale.

Power Button Zero Button

ACTIVATE DEVICE WITH APPTo correctly calibrate the POINT Unit, it is required to connect your profile to your POINT unit through the mobile app. Open the POINT app on your mobile device and follow the on-screen prompts to create your profile and complete the setup process.

6

After connecting to POINT, you will be notified if there is a firmware update available. If yousee this notification, follow the prompts to install the update.

*NOTE

If the POINT unit displays UNLOAD or LOAD at the bottom of the screen on initial power up, press the square stop button to place POINT into Gross Mode.

*NOTE

5

1 2

3 4

Scale-Tec POINTANDROID

Search for “Scale-Tec POINT” to download from the Google Play Store.

iOSSearch for “Scale-Tec POINT” to download from theApple App Store.

Use this Quick Start Guide to help you get set up and running immediately. Refer to our online help center at scale-tec.com for more information on operating your POINT.

WARNING: Never charge yourtractor battery with POINTconnected to power source.This will void your warranty.

7602008 - REVC

QUICK START GUIDEwww.scale-tec.com

16027 Hwy 64 EastAnamosa, IA 52205

(319) 462-2344