pin receptacle press-fitted to iu test pcb . ( partnumber detail on next page.)

Pin receptacle press-fitted to IU test pcb.(Partnumber detail on next page.)

front siderear side w/ PMT inserted

Note: This will not be visible on actual front PCB, it is buried in a blind hole.

measured 0.090 inch

Details of contact geometry.Cutaway view.(Necessary to solder body to a copper boardfor fixturing for cutaway. Ignore this!)

Contact with typical MCP-PMT pin inserted.

first touch 0.068 inch(at this point of pin insertion, the contact beams are first observed to deflect)

ABSOLUTE MINdesign insertion depth0.100 inch

Remarks:

• Necessarily, the minimum design insertion depth is a judgement call.

• If you ask the receptacle manufacturer, the answer will be larger still.

• Someone has to make this judgement and be responsible for the consequences.

• If you ask me, 0.100 inch (2.54 mm) is acceptable, based on my observations of the cutaway pin. A bit more would be better.

• Lastly, please note that we are talking about the minimum design insertion depth, after all tolerances are taken into account.

From the above work, we set the position of PMT face with respect to the top surfaceof the front board 14.200 BASIC, as shown below.

• And then the maximum allowable extent of the potting, measured from face of PMT, is simply defined by the need to not interfere with the pin receptacles or the front board.• A simple value of 13.489 mm maximum is acceptable (call it 13.45 mm for sanity).• Compare this to the HPK drawing, 13.80 mm. A change is necessary.