pelco 9760 cc1 computer configuration files transfer - · pdf file ·...
Post on 30-Mar-2018
224 Views
Preview:
TRANSCRIPT
Pelco 9760 CC1 Computer Configuration Files Transfer
Items Needed: 3.5” Floppy AT Keyboard (5pin Din)
Pelco 9760 System Manager (v8.xx) Once program is ready to export. Top Icon Bar, Click “Write File”. You should see what is pictured below. Click on “Select” Config File Source, (new window next slide)
Pelco 9760 System Manager (v8.xx)
Insert 3.5” Floppy into your Windows Floppy Drive Select 3.5” Floppy (A:) Select “OK” or “Save”
Pelco 9760 System Manager (v8.xx)
Once export is complete, The window will say finished. The files on your floppy disk should look as pictured.
Remove Floppy Disk.
Pelco 9760 CC1 Computer Video Out Screen View this screen if possible.
HD15 Monitor cable to a computer Monitor. Camera 500 on some systems.
Connect the composite video output of the CC1 Computer to a Video Monitor
Pelco 9760 CC1 Computer Floppy & Keyboard Connection
Insert Floppy into Floppy Drive Connect AT Keyboard
*****WARNING – Proceeding any further will disable the Pelco Matrix System. All Pelco joystick keyboards will go OFFLINE. Selecting and controlling cameras will stop.
Operators will still see the last camera they have on their monitors. When the CC1 Computer reboots, the operators will need to Log In on their Pelco joystick, plus
they may need to select the cameras they were previously viewing.******
Pelco 9760 CC1 Computer Video Out Screen
Press and hold “Control” then Press “Q” Release Both
At the dos Prompt, type in “replace” and hit Enter/Return
Pelco 9760 CC1 Computer Video Out Screen
The files will copy from the Floppy to the Hard Drive. Pressing any key at the end will automatically run the Pelco Program.
top related