network device connector - part # c156.267 installation
Post on 31-Jan-2022
7 Views
Preview:
TRANSCRIPT
Draper, Inc. | 411 S. Pearl St. Spiceland, IN 47385 draperinc.com | 765.987.7999 | 800.238.7999
© 2019 All Rights Reserved | FORM: IO_NDC_Inst19
Section 1 - Overview
Network Device Connector (NDC) is used to connect IntelliFlex I/O devices into a network.It distributes both power and communications between devices (see Fig. 1).
Features• LED indicators show network status• Built-In terminating resistor• Network bypass switch for troubleshooting
Section 2 - Mounting to Structure
1. Determine mounting location of NDC and mark on wall or ceiling.
2. Locate Mounting Bracket and provided mounting hardware (see Fig. 2).
3. Line up mounting holes on back of NDC with mounting pegs on mounting bracket.
MOUNTING PEGS
NDCSELF-TAPPING
SCREW
MOUNTING BRACKET Fig. 2
Network Device Connector - Part # C156.267INSTRUCTIONS
INSTALLATION & PROGRAMMING
Network Device Connector
Network Device Connector
Network Device Connector
Wall Switch orOther Device
RS485120VAC Motor
RS485120VAC Motor
Fig. 1
Section 3 - LED Indicators
The NDC has two LEDs named NETWORK and STATUS.LED NAME LED COLOR LED DISPLAY DESCRIPTION
STATUS LED
GREEN Power to the device
RED Network termination has been set to ON
NETWORKLED
ALWAYSYELLOW
Indicates network activity as shown in the table BELOW
NETWORK LED BLINKING PATTERNYELLOW LED ACTION: INDICATES:OFF No connection to the deviceSOLID No other devices communicating in the network
BLINKING Communicating on the network. The blink pattern shows total number of devices on network. A short blink = 1 device. A long blink = 10 devices
Section 4 - Toggle Switches
NETWORK BYPASS SWITCH when ‘ON’ removes connected device from network and allows network communication to pass through.
TERMINATION SWITCH should be set to ‘ON’ if NDC is at the beginning or end of the network, otherwise it should be ‘OFF’.
Compatible Components
NetworkDevices
Wireless Network Gateway PN: C156.268
A/V Gateway* PN: C156.269
Motors
Tools Motor Limit Tool PN: C202.030
User Input Devices
Handheld Remote PN: C156.270
Single Zone Wall Switch* PN: C112.161
Dual Zone Wall Switch* PN: C112.162
IntergrationDevices
IntelliFlex I/O Motors*
Contact Closure Interface* PN: C156.273
*One NDC is included with each of these devices
top related