neptune technology group - t-10® meter assembly instructions · 2017. 5. 10. · t-10® meter...

T-10® Meter Assembly Instructions

Chamber Assembly

2

Upper Half

Thrust Roller

Diaphragm

Ball and Disc

Outlet Gasket **Please note Outlet Gasket will be removed for competition.

Lower Half

Chamber Assembly

3

Thrust Roller

Ball and Disc

Insert thrust roller in the ball and disc.

Chamber Assembly

4

Lower Half

Ball and Disc

Insert ball and disc into lower half.

Chamber Assembly

5

Diaphragm

Lower Half

Insert diaphragm into lower half.

Chamber Assembly

6

Lower Half

Upper Half

Snap upper and lower half together.

Chamber Assembly

7

Outlet Gasket **Please note Outlet Gasket will be

removed for competition.

Chamber

Insert outlet gasket into chamber.

Meter Assembly

8

Chamber Assembly

Maincase

Place chamber assembly into meter maincase.

Ensure outlet gasket is facing the outlet of the meter.

Meter Assembly

9

Strainer

Maincase

Place strainer into meter maincase as shown above.

Ensure the strainer is fully seated and flush with the

machined surface.

Meter Assembly

10

Liner/Gasket

Meter Outlet

Place liner/gasket into meter maincase.

Ensure liner/gasket dome is facing up away from

meter.

Meter Assembly

11

Bottom Cap

Meter

Place bottom cap on meter maincase.

Meter Assembly

12

Bolts

Meter

Insert bolts into maincase and tighten them with

your finger.

Meter Assembly

13

½” Wrench

Finish tightening bolts with ½” wrench.

Complete Meter Assembly

14

Register

Flip meter over and place register on bayonet.

Secure by turning the register clockwise.