iot section 2th
Post on 09-Feb-2017
79 Views
Preview:
TRANSCRIPT
Lab 2 ( first experiment )Blinking led project
Lab tools USB cable Led light Resistor 100BreadboardThree short cables
USB cable
Led light
Resistor 100 ohm
beardboard
Short cables
Setting things up
Compile code
upload code
First problem did not choose the right port Tools - > port -> com3
Run out first program Connect to your laptop using the usb connectorLed light will light up labeled on The led light labeled l will light on and then off This is the first program The program is pre installed on the chip
Modify first program
Modify first program continue
Beard board
First program
THANK YOU
top related