flush mounted instruction
Post on 14-Mar-2016
222 Views
Preview:
DESCRIPTION
TRANSCRIPT
10
Installation: (TKW128-17D)
1..Outlook Specification
① NUT ②Gasket ③Rack Mount ④Log Screw ⑤Hanging Rod
⑥Expanding Rubber Staff ⑦Cross Sunk Screw ⑧Back Board ⑨Hook Groove
.
Hanging Stick
GasketNUTRack Mount Log screwExpanding rubber staff
Back Board
2. Installation Steps
Note: Installation are made only to interface of suitable hardness
Cut a 458Wx328Hx68(deep) mm recess in the wall board to accommodate the Back Board. The
recess in the wall should be open below the Back Board to allow cables to enter the bottom of the
11
unit. The wall should be of suitable strength to support TV.
1、Drill holes of the right size.
2、Fill in the rubber.
3、Put Embed Board into the recess hold.
4、Fix 3.5x30KM Stainless screw to fix the Back board.
5、Lift the TV carefully to put the rod into the hook groove to be stuck.
1 2Installation surface
Note:measure the position before drilling Embed Size
Mirror LCD TV IR Back Board Wires Out
top related