flha series linear high bay installation guide

CAUTION: PLEASE FOLLOW THIS INSTRUCTION MANUAL CAREFULLY TOPREVENT ANY INJURIES OR COMPLICATIONS THAT MAY ARISE.WARNING: Before installing or maintaining the luminary, make sure all power isTURNED OFF.Verify that supply voltage is correct by comparing it with the label information on allfixtures.Make all connections in accordance with the NEC requirements, and make sure allluminaries are properly secured to prevent any wire complications. This luminary isto always be installed with the lens facing down and its not to exceed the maximumambient temperature rating noted on the specification sheet.

FLHA Series Linear High Bay Installation Guide

02-00019-2

Need help? Tech help line: (800) 988-6386 Email: cs@paclights.com Website: www.paclights.com

Copyright © 2017 PacLights All Rights Reserved Note: Instructions are subject to change at any time without notice

PART NO. IMAGE DESCRIPTION QTY

AC-LHA-ACL 196 in. Aircraft Cable pair used to hang the FLHA Linear High Bay on Various Mounting Beams.

1pair

AC-LHA-ACS 120 in. Aircraft Cable pair used to hang the FLHA Linear High Bay on Various Mounting Beams.

1pair

AC-LHA-ACS/L- Linear Highbay Cable Mount Kit

Includes: FLHA2D090, FLHA2D110, FLHA2D162, FLHA4D178, FLHA4D223, FLHA4D321

Step 1- Wrap two piecesof cables across a ceilingbeam and extend down tothe required mountingheight.

Step 2- Install a JunctionBox on the ceiling beamand run down the ACPower Supply cablesinside a flexible conduit toapproximately the sameheight as the chains.

Step 3- Using the shorter aircraftcable (with two tabs on both ends),insert the two slot-shaped tabs intothe FLHA slots on both sides. Thisis accomplished by first insertingone end of the tab and using the slotto move the cable as desired to bring in the second end of the tab.Once this tab has been insertedinto the luminaire, it will be safelysecured into place for mounting.

Step 4- Here is how the cable kitshould look once installed.

PUSH

PU

LL

Step 5- Push in theshown button on the longcable member in order toadjust the length of thecable, this is used toadjust the mountingheight of the luminaire.

Step 7- Refer to the wiring diagramfor the FLHA luminaire in order to seehow to wire the AC Power onto thelumianire. Once everything is properlyinstalled, This is how the luminaireshould look.

Step 6- Remove the screw on this long cable member using a 3 mm allenwrench, insert the short cable member inside the two slotted sides and fastenthe set screw. This is to union the two cable members together.

Step 5- Remove the cover plate inorder to access wires required forinstallation. Have an AC PowerSupply Conduit with a J-Boxattacked to the ceiling come downto approximately the same heightof the chains. Use the WiringDiagram provided above toproperly wire the luminaire to thepower supply. All wiringconnections must be made eitherinside a Junction Box or the backhousing of the luminaire.