first paper feed area table height adjustment: there are two ways of adjusting the upper limit...

First Paper Feed Area

Table Height Adjustment:There are two ways of adjusting the upper limit sensor.

1. You can put two sheets of paper on the paper feed tray and hit “TEST PRINT”.

This should then leave one sheet of paper remaining on tray. Turn machine off and check gap between feed wheel and paper feed tray.

The gap should be between 1 to 2 mm.

Adjustment Screw

2. The other way to adjust the upper limit sensor is to run TM 102. After executing TM102, push green elevator button until paper feed tray stops at top position.

Precautions on Adjustment:

Ensure that “Normal” is selected Not “CARD”

Second Paper Feed Area

Adjustment of Timing Lever:

Precautions on Adjustment:

After performing timing lever adjustment, rotate machine to home position and ensurethat card stock or a envelope can pass between guide and timing roller smoothly without resistance. If not perform timing plate adjustment.

Second Paper Feed Area

Adjustment of Timing Plate:

Second Paper Feed Area

Skew Adjustment:

Precautions on Adjustment:

If you have severe skew copies, please make sure that bracket holding timing roller is not broken.

Screw head snaps off

Bracket holding Timing Roller

Main Drive

Loosen Screw x 3 and jump cam pulley.

Precautions on Adjustment:

Make sure you know what model you are

working on eg. B4, A3

Timing Points

Adjustment of Timing:

Main Drive

Start time of first paper feed.

Precautions on Adjustment:

Make sure you know what model you are

working on eg. B4, A3

Adjustment of P-Disc

Main Drive

Adjustment of Pressure Sensor Disc

Alignment Hole

Main Drive

Adjustment of Vertical Print Position:

Precautions on Adjustment:

Always ensure that your timing is correct before adjusting vertical print position.

Drum Adjustments