fasteners assignment part c: 3/8-16 unc-2a 1.5 flat head
Post on 24-Feb-2016
24 Views
Preview:
DESCRIPTION
TRANSCRIPT
Fasteners AssignmentPart C: 3/8-16 UNC-2A 1.5 FLAT HEAD
Check PDF packet page one for quick reference
to page numbers…
Start by drawing the following vertical
rectangle .375x1.5
• Offset top line down ½ D (0.1875)• Draw a line from the blue circle intersection
heading “@1<50”• Mirror angled line over to the left side of
the fastener and fillet, trim, extend, / erase.
Add slot for screw driver. Dimensions for height and width are 1/4D as
noted in the book example.
• Check last page of PDF for dimensions of steel plates.
• Top plate has a clearance hole for the fastener.
• Bottom plate is tapped (threaded)- See page 1 of PDF for page number referencing
threaded holes• Bottom plate has more threads cut than
length of bolt, i.e. bolt can’t bottom out without fully tightening down.
• Pilot hole (pre-drilled hole before tapping can occur) extends lower than threads and has 80 degree angle (same as the twist drill bit that cut the hole). Dimensions can be
“eye balled.”
top related