et dignitas guangdong institute of education ---btec electronic amor electronics chapter 4 negative...

Post on 29-Mar-2015

212 Views

Category:

Documents

0 Downloads

Preview:

Click to see full reader

TRANSCRIPT

Slide - Slide - 11

Guangdong Institute of Education ---Guangdong Institute of Education ---BTEC electronicBTEC electronic

Electronics chapter 4 negative feedback

Review0、 introduction1、 what is feedback?2、 why we need feedback in our circuit?3、 how many types of feedback?4、 how many types of negative feedback?5、 how to judge all kinds of negative feedback?6、 advantages of negative feedback?7 、 how to analyse the negative feedback circuit?8 、 conclusion----- assignment

Slide - Slide - 22

Guangdong Institute of Education ---Guangdong Institute of Education ---BTEC electronicBTEC electronic

Electronics chapter 4 negative feedback

introduction

An audio-frequency amplifier can be designed to have a certain current, voltage or power gain together with particular values of input and output impedance.

The amplifier will add noise and distortion to the signals handled by it. The components employed in the amplifier, both passive (resistors, capacitors, etc.) and active (transistors and f.e.t.s), will vary in value with both time and change in temperature and will have manufacturing tolerances.

Slide - Slide - 33

Guangdong Institute of Education ---Guangdong Institute of Education ---BTEC electronicBTEC electronic

Electronics chapter 4 negative feedback

introduction

The gain of the amplifier may therefore vary with

time, with change in ambient temperature, and when

a component has to be replaced by another of the

Same type and(nominal)value.

any fluctuations in the power supply may also cause

the gain of the amplifier to alter.

Slide - Slide - 44

Guangdong Institute of Education ---Guangdong Institute of Education ---BTEC electronicBTEC electronic

Electronics chapter 4 negative feedback

feedback

R110kΩ

R210kΩ

R3240Ω

R41kΩ

RL

C1

4.7uF

C2100uF

C3

47uF

VCC

12V

IO1IO1

IO2

IO3

IO4

IO3

0

Q1

2N914

10

9

1

R5

470kΩKey=A

50% VCC

2

Ui

Uo

Ii

Io

1 、 what is feedback?

2 、 For many applications a more or less constant gain iS necessary , and this can be obtained if negative feedback (n.f.b.) iS applied to the amplifier, at the

expense, however,of a reduction in gain.

Slide - Slide - 55

Guangdong Institute of Education ---Guangdong Institute of Education ---BTEC electronicBTEC electronic

Electronics chapter 4 negative feedback

Slide - Slide - 66

Guangdong Institute of Education ---Guangdong Institute of Education ---BTEC electronicBTEC electronic

Electronics chapter 4 negative feedback

why we need feedback in our circuit?

1、 make our circuit stabilization:Quescent operation point;Stability of gain: current gain, voltage gain;Decrease non-linearity distortionReduces noiseChange input and output impedanceReduces amplitude/ frequency distortion 2、 generate oscillation (oscilloscope)

Slide - Slide - 77

Guangdong Institute of Education ---Guangdong Institute of Education ---BTEC electronicBTEC electronic

Electronics chapter 4 negative feedback

Types of feedback

0 、 d.c feedback1 、 a.c. feedback2 、 positive feedback3 、 negative feedback4 、 voltage feedback 5 、 current feedback 6 、 Series feedback7 、 parallel feedback

Slide - Slide - 88

Guangdong Institute of Education ---Guangdong Institute of Education ---BTEC electronicBTEC electronic

Electronics chapter 4 negative feedback

chapter 4 negative feedback

4.2 types of negative feedback

4.2.1.voltage-voltage feedback,

4.2.2.voltage-current feedback,

4.2.3.current-current feedback.

4.2.4.current-voltage feedback.

Slide - Slide - 99

Guangdong Institute of Education ---Guangdong Institute of Education ---BTEC electronicBTEC electronic

Electronics chapter 4 negative feedback

Slide - Slide - 1010

Guangdong Institute of Education ---Guangdong Institute of Education ---BTEC electronicBTEC electronic

Electronics chapter 4 negative feedback

The negative feedback

An n.f.b. amplifier has a fraction of its output signal feed back into its input terminals in antiphase with the input signal.

four types:voltage-voltage feedback,

voltage-current feedback,

current-current feedback.

current-voltage feedback.

Slide - Slide - 1111

Guangdong Institute of Education ---Guangdong Institute of Education ---BTEC electronicBTEC electronic

Electronics chapter 4 negative feedback

Voltage-Voltage Feedback(Series-voltage Feedback)

Slide - Slide - 1212

Guangdong Institute of Education ---Guangdong Institute of Education ---BTEC electronicBTEC electronic

Electronics chapter 4 negative feedback

S IN OUTV V V

OUT v S v IN OUT v IN v OUTV AV A V V AV AV

(1 )OUT v v INV A AV (1 )

v INOUT

v

AVV

A

( ) (1 )OUT v

v FIN v

V AA

V A

Voltage gain with n.f.b.

Slide - Slide - 1313

Guangdong Institute of Education ---Guangdong Institute of Education ---BTEC electronicBTEC electronic

Electronics chapter 4 negative feedback

EXAMPLE 4.1

A voltage amplifier has a voltage gain of 100 before n.f.b.is applied.Calculate its voltage gain if 3/100 of the output voltage is fed back to the input in antiphase with the input signal.

Solution:

From equation(4.1),

( )

100 10025

(1 3/100 100) 4OUT

v FIN

VA

V

Slide - Slide - 1414

Guangdong Institute of Education ---Guangdong Institute of Education ---BTEC electronicBTEC electronic

Electronics chapter 4 negative feedback

The voltage gain of a transistor amplifier without n.f.b.iS

The effective load resistance RL(eff)seen by the transistor in an emitter follower circuit iS the resultant of the emitter resistor R3 in parallel with the external load resistance RL.The voltage gain of an emitter follower is

i Lv

IN

ARA

R

( ) ( )( )

( ) ( )

/

1

i L eff IN i L effv F

i L eff IN i L eff

IN

AR R ARA

AR R ARR

Slide - Slide - 1515

Guangdong Institute of Education ---Guangdong Institute of Education ---BTEC electronicBTEC electronic

Electronics chapter 4 negative feedback

Voltage-Current Feedback(Series-current Feedback)

Slide - Slide - 1616

Guangdong Institute of Education ---Guangdong Institute of Education ---BTEC electronicBTEC electronic

Electronics chapter 4 negative feedback

When voltage-current feedback is applied to an amplifier the fed-back voltage is proportional to the current-flowing in the load.

OUT OUT F

OUT OUT L

V I R

V I R

F

L

R

R 3i

vIN

ARA

R

3

3( )

34 4

3

1 .

i

IN iv F

i IN i

IN

AR

R ARA

ARR R ARR R

2 2( )

3 32

2

11 .

m mv F

mm

g R g RA

R g Rg RR

Slide - Slide - 1717

Guangdong Institute of Education ---Guangdong Institute of Education ---BTEC electronicBTEC electronic

Electronics chapter 4 negative feedback

EXAMPLE 4.5

An amplifier of the type shown in Fig.4.8b has the following data:R2=4.7 kΩ,R3=1 kΩand gm=5 mS.Calculate the voltage gain of the circuit.

Solution

From equation(4.6) 3 3

( ) 3 3

5 10 4.7 103.92

1 5 10 10v FA

Slide - Slide - 1818

Guangdong Institute of Education ---Guangdong Institute of Education ---BTEC electronicBTEC electronic

Electronics chapter 4 negative feedback

Current-Current Feedback(Shunt-Current Feedback)

Slide - Slide - 1919

Guangdong Institute of Education ---Guangdong Institute of Education ---BTEC electronicBTEC electronic

Electronics chapter 4 negative feedback

1

1 2

OUT FOUT

F F

I RI

R R

1

1 2

F

F F

R

R R

S IN OUTI I I

( )OUT i S i IN OUTI A I A I I

(1 )OUT i i INI A A I (1 )

i INOUT

i

A II

A

( ) (1 )OUT i

i FIN i

I AA

I A

Slide - Slide - 2020

Guangdong Institute of Education ---Guangdong Institute of Education ---BTEC electronicBTEC electronic

Electronics chapter 4 negative feedback

Current-Voltage Feedback ( Shunt-voltage Feedback)

Slide - Slide - 2121

Guangdong Institute of Education ---Guangdong Institute of Education ---BTEC electronicBTEC electronic

Electronics chapter 4 negative feedback

/OUTOUT FI V R

OUT

OUT F

OUTOUT

L

VI R

VIR

L

F

R

R

Slide - Slide - 2222

Guangdong Institute of Education ---Guangdong Institute of Education ---BTEC electronicBTEC electronic

Electronics chapter 4 negative feedback

EXAMPLE 4.6

Calculate the current gain of the circuit shown in Fig.4.12a if the current gain of the transistor is 120.

Solution

The feedback factor is (Ans.)

Therefore

Current gain with feedback

(Ans.)

2

1

3 1

120 40

R

R

( )

120 12030

1 41 12040

i FA

Slide - Slide - 2323

Guangdong Institute of Education ---Guangdong Institute of Education ---BTEC electronicBTEC electronic

Electronics chapter 4 negative feedback

Slide - Slide - 2424

Guangdong Institute of Education ---Guangdong Institute of Education ---BTEC electronicBTEC electronic

Electronics chapter 4 negative feedback

Slide - Slide - 2525

Guangdong Institute of Education ---Guangdong Institute of Education ---BTEC electronicBTEC electronic

Electronics chapter 4 negative feedback

Slide - Slide - 2626

Guangdong Institute of Education ---Guangdong Institute of Education ---BTEC electronicBTEC electronic

Electronics chapter 4 negative feedback

Negative Feedback

Slide - Slide - 2727

Guangdong Institute of Education ---Guangdong Institute of Education ---BTEC electronicBTEC electronic

Electronics chapter 4 negative feedback

4.3 advantages of negative feedback4.3.1. stability of gain4.3.2.amplitude/frequency distortion4.3.3.non-linearity distortion4.3.4.noise4.3.4.input and output impedance4.4 instability in negative feedback amplifiers4.5 operational amplifiers4.5.1.operational amplifier parameters4.5.2.inverting and non-inverting amplifiers4.5.3.frequency compensation

top related