engineering questions example of pcb design
Post on 12-Jul-2015
83 Views
Preview:
TRANSCRIPT
To:
Customer Reply :
Q1 we could see these 6 holes with 0.3mm size are not in the center of copper pads. It isabnormal. We suggest to move these 6 holes to the center of the pads as pics, is it ok?
Caring�Circuit�Tech�LimitedT�+86�755�8693�6426 |�E��care@caringcircuit.com�|�W�www.caringcircuit.com� |��Skype:�caringcircuit�
Mark****CompanyBilling To: ***Ship To: *****
Customer Reply :
Customer Reply :
Q2.Two NPTH 0.89mm are drilled on line. It will cause the line cut after drilling. Another four holes0.89mm circled are for same component. Pls choose,
A. We suggest to make these 6 holes 0.89mm to PTH.
B. Pls advise how to change or send us new gerber.
top related