corner rounding end mills - harvey tool

Corner Rounding End MillsHarvey Tool’s Specialty Profiles

Products, Features, & Benefits

Corner Rounding End Mills Flared 2 & 4 Flute

NewSizes

Stocked in 2 and 4 flutes

• Flares are tangent to radius (flare is blended to radius to ensure smooth form) • Double-ended• Axial depth of cut = radius plus .005˝

Corner Rounding End Mills Unflared 2 & 4 Flute

Unflared shoulder and pilot for full radius form

• Double-ended• Axial depth of cut = radius plus .005˝• End cutting• Stocked in Uncoated, Tin Coated, AlTiN Coated

and Amorphous Diamond

Corner Rounding End Mills Long Reach - Flared

NowCoated

Reduced diameter for clearance along walls and in small features

• Small pilot design for miniature holes, narrow slots and small inside corners

• Flares are tangent to radius (flare is blended to radius to ensure smooth form)

• Axial depth of cut = radius plus .005”

Corner Rounding End Mills Flared3 Flute, Solid Carbide

5° flares tangent at pilot and shoulder to avoid steps

• Cutting on radius and end only (not center cutting)• Single end• Axial depth of cut = radius plus .005”

Corner Rounding End Mills Flared3 Flute, Carbide Tipped

5° flares tangent to radius at pilot and shoulder to avoid steps

• Carbide tipped - cutting on radius only• 3 flutes, weldon flat

Corner Rounding End Mills FlaredBack Corner Rounding End Mills - Flared

Designed to mill radius on back side of workpiece

• 5° flares at neck and shoulder to avoid steps• Flares are tangent to radius (flare is blended to

radius to ensure smooth form)• Cutting on radius and flares only