circle cutter instructions -...

Circle Cutter Instructions

CLEAR PLASTICCUTTING BOARD

DESIGN TO CUT

CIRCLE CUTTER

Place the clear plastic cutting board on a smooth, flatsurface. Put the design to be cut on the cutting board.

Using the inside edge of the cutter as a guide, center thecutter over the design.

STOP - If you are making photo buttons, the photographmust be cut to the same size as the front shell. See“Reversing The Cutting Blade” below.

With one hand, hold the outer edge of the cutter firmly tothe cutting board. Applying moderate pressure downwardon the handle, rotate the cutter handle once to cut thedesign.

1.

2.

3.

CUTTER HANDLE

1.

2.

3.

4.

CAUTION Use extreme caution when handling cutterblades. Even the dull ones can cause personal injury.

NOTE When changing the blade, you need only removethe cutting arm assembly from the cutter body. SeeDiagram 1 if you need assistance in locating and replacingother components.

To replace a worn blade, first remove the screw andcutting arm assembly from the cutter (see Diagram 1).

Remove clip holding the blade and washers to the arm.Remove the washers and old blade (see Diagram 2). (Theposition of the washers shown in the diagrams are for illustration purposesonly. Your cutter may have the washers in a different position. Make a noteof their positions on your cutter.)

Replace with a new blade making sure the washers areplaced back on the arm in the same position in which theywere removed.

Replace the cutting arm assembly making sure that theblade and black knob are on the same side of the cutter.

Changing B lades

DIAGRAM 1

SCREW

CUTTING ARMASSEMBLY

BLADE

Revers ing The Cutt ing B lade

MR. BUTTON PRODUCTS, INC. 7840 ROCKVILLE ROAD INDIANAPOLIS, IN 46214PHONE 1-800-777-0111 FAX 1-317-273-4344

DIAGRAM 3

CUTTER BODY

NYLON WASHERS (2)

NYLON SLEEVE

STEEL WASHER

SPRING

CUTTER HANDLEASSEMBLY

DIAGRAM 2

REMOVE CLIP FIRSTWASHERS

BLADE

CUTTING ARM

1.

2.

3.

When cutting photographs, it is necessary to reverse the bladeso it will cut the picture the same size as the front shell. Followthese steps to reverse the blade.

Disassemble the cutting arm assembly as shown above inDiagrams 2. Reverse the blade as shown in Diagram 3 andreplace on cutting arm.

Be sure to replace all washers in the same positions from whichthey were removed.

Replace the cutting arm assembly making sure that the bladeand black knob are on the same side of the cutter.