certificate of fda compliance · certificate of fda compliance manufacturer: fenner drives 311 west...

Certificate of FDA Compliance Manufacturer: Fenner Drives 311 West Stiegel St. Manheim, PA 17545 Product: Eagle® Blue 80 MD Date of Declaration: July 13, 2012 The monomers and additives used to manufacture this product are listed in US FDA

food-contact regulations CFR 21 177.1680, CFR 21 177.2600 and CFR 21 178.3297 relating to polymers and articles intended to come into contact with foodstuffs. The above product has been independently tested for migration with the simulants and test conditions listed below as defined in CFR 21 177.2600.

The migration results were found to be below the limits defined in CFR 21 177.2600. The above product has been independently tested for abrasion resistance following ASTM D968-81 "Standard Test Methods for Abrasion Resistance of Organic Coatings by the Falling Abrasive Tester" as outlined in CFR 21 177.1680.

The abrasion results were found to be below the limit defined in CFR 21 177.1680.

The named product is manufactured according to CFR 21 110 on “Current Good Manufacturing Practice in Manufacturing, Packing, or Holding Human Food.”

Duration Temp 7 hours 2 hours

Hexane 7hours + 2 hours Reflux Temp. 175mg/in^2 4mg/in^2

Water 7 hours + 2 hours Reflux Temp. 20mg/in^2 1mg/in^2

Food SimulantsTest Conditions Limits

Test Conditions Limit

100 liters of Sand 0.001" per 20 liters

2

Therefore, the named product fully complies with the regulations indicated and may be used in repeat food contact applications at temperatures up to 150°F for all foods with an alcohol content less than 8%. Jeremy Bigler July 13, 2012