3d printed face shield prepare - page 1 ......3d printed face shield warning: for use at own risk....
Post on 05-Jul-2020
2 Views
Preview:
TRANSCRIPT
3D PRINTED FACE SHIELDWARNING: FOR USE AT OWN RISK. This mask has NOT been approved by an official medical organization. Not for continued use after COVID-19 pandemic emergency.
Attach elastic band
Get started
Prepare plastic sheets
Test elastic band
• TUG FIRMLY on both knots to make sure the band is secure
• TRIM off excess elastic
• Ensure all materials are sanitized after use
Replace band as needed
Attach elastic band toHead Frame
• Pull elastic loop around CLEATS on both ends of head frame
• ENSURE elastic is not twisted between the cleats
5
Punch holes
• FEED the 11 inch side into hole punch
• PUSH down on top of hole punch firmly
• Check to ensure edges are clean and straight
7
Gather supplies
3D Printed Head Frame
Elastic Band 13” - 14“ in length
2x 8.5” x 11” Rigid Clear Plastic Sheetsex. Binder cover, report cover
1
6
3 Hole Punch(standard)
Scissors
Ball Point Pen
Ruler
!
CLEAT
!
Prepare elastic band
Measure elastic band
• CUT elastic13 - 14 inches in length
2 Tie Overhand Loops on each end
• CREATE LOOP A at the end of elastic
• FEED LOOP B through back of LOOP A
• HOLD end of LOOP A and PULL ON LOOP B to tighten
3 Check length
• MEASURE 9”-10” from each loop
4
PREPARE - PAGE 1
13”-14”
LOOP B
LOOP A
9”-10”
Create Top Shield
• MEASURE, MARK & CUT three 3” strips
For more precision, use a craft knife or a cutting board.
Punch holes in remaining strips for two more face shields!
83 INCHES
Attach top shield
Link to the STL for the 3D Printed Face Shield here:www.covidsupplyconnection.com
Attach Small Plastic Sheet
• Line up holes up with pegs and snap into placeExpect to feel some tension at the last peg.
11
Attach bottom shield
Attach Large Plastic Sheet
• Line up holes up with pegs and “snap” into placeExpect to feel some tension at the last peg.
10 SNAP!
SNAP!
3D PRINTED FACE SHIELDWARNING: FOR USE AT OWN RISK. This mask has NOT been approved by an official medical organization. Not for continued use after COVID-19 pandemic emergency.
Get startedGather parts
3D Printed Head Frame with Elastic Band attached
3” x 11” plastic sheet
8.5” x 11” plastic sheet
9
!ASSEMBLY - PAGE 2
WARNING: Take precautions when delivering. Wear protective gear like masks and gloves.
DO NOT deliver when sick.
!
top related