2014-2016 toyota tundra - amazon s3€¦ · 2014-2016 toyota® tundra® grille installation...
Post on 02-Jun-2020
1 Views
Preview:
TRANSCRIPT
It is strongly recommended that this product be installed by a professional.
Installation of this product requires cutting of your factory installed grille. Your factory grille will be unusable after it has been cut.
important
kit includes
5/16 x 5/8 Socket Button Cap Screws
5/16 Stainless Steel Flat Washers
5/16 x 1.25” Socket Button Cap Screws
Plastic Spacers (JK Hood)
5/16 Nylon Insert Lock Nuts
3/8 Long Plastic Spacers
M6x1x30mm Socket Button Cap Screws
M6 Stainless Steel Flanged Lock Nuts
(6)
(10)
(4)
(4)
(10)
(4)
(4)
(4)
®
2014-2016 Toyota® tundra®
grille installation instructions
20" E-Series
D-Series - Pair
®
®
Always disconnect battery before servicing any fuses or electrical system.
Before you can mount your new Rigid Industries grille, you need to remove the factory grille from the grille shell. Use the following procedure for removal. Remove (4) four 10mm screws on the factory grille shell.
step 1
Remove 2 factory clips by prying up on the center tab. Remove grille shell.
step 2
Remove
Remove
Cut the center plastic out of the factory shell as shown.
step 3
The top of the factory grille should have a nice clean cut. Use masking tape to protect the factory chrome or paint when aligning the new mesh.
step 4
Mark and drill the side tabs. Place new mesh inside factory shell. Align top of the factory grille with the notch on the new mesh.
step 6
Mark and Drill
Your grille has been bent to match the contour of the 2014 Toyota Tundra grille shell. It was tested in a sample grille shell and adjusted by hand to mount as cleanly as possible. However, the metal is easily bendable when not attached to a
Place the new mesh in place and mark your (6) six lower tabs and drill them out.
step 5
Mark Drill
Use the 1.25 long pan head bolt with the spacer between the tab and factory plastic shell.
step 8
Use the following steps to attach your grille to the shell and then attach the lights to the new grille. Bolt the (6) six lower tabs in with a washer and lock nut on the bottom of the grille shell.
step 7
Bolt Together
Bolt Spacer
Bolt the factory shell back on in reverse order.
step 10
When insalling the 20” E-Series light bar slide it all the way forward and slide it up to angle the light up and down. Install the D-Series lights with a
step 9
Bolt BackTogether
Spacer
Your installation is now complete.
Welcome to the Rigid Nation!
®
Visit us at Rigidindustries.com to check out more great LED
lighting options for your TOyota!
e-series
SR-series
SR-Q
SR-M
D-series
a-series
®
®
®
®
®
®
Follow us on facebook at Facebook.com/RigidIndustries
779 N Colorado St, Gilbert, AZ 85233 • 855-760-5337 • www.rigidindustries.comPKG-IS-025-B
Rigid Industries, Rigid, D-Series, E-Series, SR-Series, SR-M Series, SR-Q Series, and A-Series are registered and/or common law marks owned by JST Performance, LLC, a Delaware limited liability company d/b/a Rigid Industries.
For warranty information, visit www.rigidindustries.com/about/warrantyWARRANTY INFORMATION
Your installation is now complete.Welcome to the Rigid Nation!
top related