agricultural use of wood ashor compounds exceed prescribed limits, the ash is classified as a...

16
Agricultural Use of WOOD ASH in California UNIVERSITY OF CALIFORNIA Agriculture and Natural Resources Publication 21573

Upload: others

Post on 17-Apr-2020

1 views

Category:

Documents


0 download

TRANSCRIPT

Agricultural Use of

WOOD ASH in California

UNIVERSITY OF CALIFORNIAAgriculture and Natural ResourcesPublication 21573

B

AGRICULTURAL USE OF WOOD ASH IN CALIFORNIA

ROLAND D. M EYER

Extension Soils Specialist , Department of Land , Air and Water Resources, University of California , Davis

D ANIEL B. MARCUM

University of California Cooperative Extension Farm Advisor, Shasta-Lassen Countie s

H OLLY A. G EORGE

University of California Cooperative Extension Farm Advisor, Plumas-Sierra Counti es

GARY G . M ARKEGARD

University of California Cooperative Extension Farm Advisor, Humboldt Count y

G ARY M . NAKAMURA

Extension Forestry Specialist , Department of Ecosystem Science, Policy, and Management , University of California, Berkeley

According to the California Integrated Waste Management Boards Phase 1 Report, Ash Quantification and Characterization Study (Khan et al. 1992), approximately one-half million tons of wood ash were produced in California in 1989. Although most ash was initially taken to landfills, it is now being used in a variety of ways. Many of the current uses are in response to a California law (Public Resources Code §40000 et seq. [AB 939]) requiring the development of alternative disposal measures to reduce the amount of material sent to landfills. Since the mid- l 980s , University of California Cooperative Extension personnel and many cooperating landowners have conducted field research studies to examine how wood ash can be used in agriculture. This publication discusses the benefits and potential risks of using wood ash as a low-value liming material and plant nutrient source in order to assist potential users of wood ash in distinguishing beneficial from nonbeneficial agricultural uses.

Origin and Composition of Wood Ash

Wood-fueled power plant ash (bottom ash and fly ash) is a byproduct of steam generation that is produced by burning wood chips in a furnace at 1,400° to l ,900°F (766° to l ,046°C). The wood fuel comes from in-forest operations , orchards, sawmills (bark, sawdust, shavings , or wood chips) , and occasionally urban trees and shrubs (tree stems, limbs, stumps , leaves, or needles). One bone dry ton (BDT)

(100 percent dry matter) of wood fuel produces about 1 megawatt-hour of electricity, sufficient to power 1,000 homes for 1 hour. Depending on the combustion character­istics of the furnace , 1 BDT also produces 3 to 7 cubic feet (0.08 to 0.20 m3) of ash, which may weigh from 10 to 100 pounds per cubic foot (160 to 1,600 kg!m3) .

It is very important that ash produced from wood fuel ( wood ash) be distinguished from ash produced from other fuel sources, particularly coal, sewage sludge, or urban waste. These other ash materials may contain lead and other heavy metals or organic compounds from burning plastics or petroleum products . They may not be suitable for agri­cultural applications . If the concentrations of these elements or compounds exceed prescribed limits, the ash is classified as a hazardous waste according to Title 22 of the California Code of Regulations.

The composition of wood ash is determined largely by the type of power plant , whether bottom and fly ash are mixed together, and how the ash is collected and removed from the facility. Wood ash typically contains carbon (unburned wood), calcium, magnesium , sodium, potassi­um , and phosphorus , and it may also contain beneficial amounts of sulfur, zinc, copper , and other micronutrients (fig. 1). Boron, molybdenum , and selenium may also be present at low concentrations , depending on the wood used in the power plant.

Some power plants produc e a "high-carbon " ash as a result of incomplete combustion of fuel, while others pro­duce a "low-carbon" ash. High-carbon ash can consist of

2

3

4

Plate 1. Chipped wood, a fuel used by many power plants. Plate 2. Large piles of wood chips are mixed together before being burned in the power plant in the background.

Plate 4. Large blocks of ash, rocks, and other debris should be removed from ash before spreading in the field.

Plate 3. Two most common types of ash: high-carbon black ash, left, and low-carbon gray ash, right.

Plate 5. A spreader equipped with a grate or screen on the top can be used to remove large particles from the ash.

Plate 6. A wide opening in the spreader—24 to 28 inches (61 to 71 cm) wide, as shown here—allows ash to feed properly onto the spinners for uniform distribution in the field.

24 – 28”

Plate 7. Ash application rates (100 percent dry matter basis) on rangeland: 20 tons per acre (45 Mg/ha), right; 40 tons per acre (90 Mg/ha), left and in back; and 80 tons per acre (180 Mg/ha), center foreground.

Plate 8. Ash applied on irrigated pasture at 16 dry tons per acre (36 Mg/ha). The inset shows a close up of no ash, left, and ash applied at 16 dry tons per acre, right.

Plate 9. A truck with a moving floor unloads ash in strips in a field.

Plate 10. Driving stakes in the field at planned spacing and inter-vals provides for more accurate rates of application.

Plate 12. Small, uniform windrows that are more closely spaced allow for uniform spreading in the field.

Plate 11. A large dump truck unloading ash in piles in a field.

Plate 13. A grader, scraper (shown here), blade, or landplane traveling perpendicular to the windrows can be used to spread the ash uniformly in the field.

Plate 14. Ash is incorporated effectively using a large tandem or double disk with disks 18 to 24 inches (45.5 to 61 cm) in diameter.

Plate 15. A second pass over the field with the tandem disk at a 45° to 90° angle to the first disking assures more complete incorporation of the ash.

Plate 16. An aerial photograph showing very uneven spreading of ash in a field. Uneven spreading decreases the benefit of ash to crops.

Plate 17. Areas of high ash application rates may reduce germination and early seedling growth, resulting in very low crop yields.

8

Plate 20. Avoid storing or applying ash near streams or intermittent watercourses.

Plate 22. Avoid excessive movement by wind during spreading and incorporation of ash.

Plate 21. Ash should be stored in areas surrounded by trees where it can be protected from movement by wind. Some movement is unavoidable during loading and spreading of ash.

Plate 18. The quarter gives a perspective as to how great-ly plant density has been reduced by heavy ash applica-tion compared to the upper right corner of photo, where a higher plant density exists.

Plate 19. A large legume-wheat plant growth response of greater than 2.5 tons per acre (5.6 Mg/ha) from ash application of 100 dry tons per acre (225 Mg/ha), left, compared to no ash, right. The soil was slightly acidic (pH 5.7) and low in phosphorus and potassium.

9

10

11

12

To order or obtain ANR publications and other products, visit the ANR Communication Services online catalog at http://anrcatalog.ucanr.edu/ or phone 1-800-994-8849. Direct inquiries to

University of CaliforniaAgriculture and Natural ResourcesCommunication Services2801 Second StreetDavis, CA 95618Telephone: 1-800-994-8849 Email: [email protected]

© 1999 The Regents of the University of CaliforniaThis work is licensed under the Creative Commons Attribution-NonCommercial-NoDerivatives 4.0 International License. To view a copy of this license, visit http://creativecommons.org/licenses/by-nc-nd/4.0/ or send a letter to Creative Commons, PO Box 1866, Mountain View, CA 94042, USA.

Publication 21573ISBN-13: 978-1-62711-069-3

The University of California, Division of Agriculture and Natural Resources (UC ANR) prohibits discrimination against or harass-ment of any person in any of its programs or activities on the basis of race, color, national origin, religion, sex, gender, gender expression, gender identity, pregnancy (which includes pregnancy, childbirth, and medical conditions related to pregnancy or child-birth), physical or mental disability, medical condition (cancer-related or genetic characteristics), genetic information (including family medical history), ancestry, marital status, age, sexual orientation, citizenship, status as a protected veteran or service in the uniformed services (as defined by the Uniformed Services Employment and Reemployment Rights Act of 1994 [USERRA]), as well as state military and naval service.

UC ANR policy prohibits retaliation against any employee or person in any of its programs or activities for bringing a complaint of discrimination or harassment. UC ANR policy also prohibits retaliation against a person who assists someone with a complaint of discrimination or harassment, or participates in any manner in an investigation or resolution of a complaint of discrimination or harassment. Retaliation includes threats, intimidation, reprisals, and/or adverse actions related to any of its programs or activities.

UC ANR is an Equal Opportunity/Affirmative Action Employer. All qualified applicants will receive consideration for employment and/or participation in any of its programs or activities without regard to race, color, religion, sex, national origin, disability, age or protected veteran status.

University policy is intended to be consistent with the provisions of applicable State and Federal laws.Inquiries regarding the University’s equal employment opportunity policies may be directed to: Affirmative Action Contact and Title IX Officer, University of California, Agriculture and Natural Resources, 2801 Second Street, Davis, CA 95618, (530) 750-1397. Email: [email protected]. Website: http://ucanr.edu/sites/anrstaff/Diversity/Affirmative_Action/.

web-11/18-SB/VG/WS