adaptor

commonsense

2. ON/OFF switch3.Handle

Speed n0: 9000 min-1

Battery type: Li-IonCutting range: 26 cm diameterMax. running period: 30 min4. Front handle

5. Height adjustment bar6. Edge guide7. Telescope tube 8. Safety guard9. Pedal for angle adjustment10. Battery charger 11. Battery x212. 2 Securing screws for safety hood13. Locking knob 14. Line spool

10

4. Before starting

4.1 Installing the safety hood (B3-B5)

. Secure the edge guide to the safety guard (B3).

. Place the safety guard on the trimmer (B4) andsecure to the trimmer (B5) it using the 2 securing screws (B2 / Item 12).

4.2 Installing the front handle (B6)

Undo the securing screw from the handle andthen place the handle on the main handle and secure it with the screw (B6).

4.3 Height adjustment (B10)

Undo the union nut (B10/Item 5) until the grasstrimmer handle can be moved in and out freely. Now set the required working height and secure the handle in this position by tightening the union nut again.

4.4 Adjusting the front handle (B6)

Undo the securing screw on the front handleuntil it can be moved forwards and backwards without any great resistance. Set the required position and tighten the securing screw again.

4.5 Adjusting the angle of the guide handle(B11)

the pedal for adjusting the angle from above using your foot (B11/Item 9). You can now set the handle to the required angle. Release the pedal and allow the handle to lock into position to

possible.

4.6 Charging the battery (B12-B14)

• Press the snap fastening and remove the battery (11).

• Place the plug of charger (10) in a 240 V~/50Hz socket.The green LED will be permanently lit.- Push the battery pack onto the battery charger. The red LED will come on to indicate that the battery pack is being charged. When the

permanently lit. The time it takes to fully recharge an empty battery is approximately 1 hour.

• Push the battery into the machine with cleancontacts until it engages.

Recharging

• Regular recharging after lengthy use and afterlengthy periods of inaction will extend the servicelife of the battery.

5. Operation

IMPORTANT! Make sure that you unplug therechargeable battery before adjusting the linelength !

The grass trimmer has a semi-automatic lineextension system. Each time you activate the semiautomatic line extension system, the line will be extended to ensure that you can cut your lawn

. Make several passes to cut long grass shorterstep by step from the top (see B18).

. Use the guard prevent unnecessarywear.

. To avoid unnecessary wear, keep the grasstrimmer away from hard objects.

Using the grass trimmer as an edge trimmer

The grass trimmer can be adjusted as follows to trim the edge of lawns and beds.

. The grass trimmer can then be adjusted for useas an edge trimmer for making vertical cuts onthe grass (B15).

with the perfect cutting width at all times.Please note that the wear on the line will beincreased if you activate the semi-automatic lineextension system frequently.

NoteIf the line is too long when you use the

will be cut by the blade on the safety guard.

If the line is too short when you start the

the line spool and pull the line hard. When

the line will be cut to the perfect length automatically.

Remove the knife guard. Caution: Risk of injury!Now insert the rechargeable battery. Theline will be cut to the correct length when the cutting head starts up again. A short or worn nylon line produces poor cutting results.

Your grass trimmer will work at its best if youobserve the following instructions:

. Never use the grass trimmer without its safetydevices.

. Do not cut grass when it is wet. The best resultsare obtained on dry grass.

. To switch on your grass trimmer, press the

. ON/OFF switch (B1/Pos. 2).

. Do not move the grass trimmer against the grassuntil the switch is pressed, i.e. wait until thetrimmer is running.

. For the correct cutting action, swing the grasstrimmer to the side as you walk forward, holdingit at an angle of approx. 30° as you do so (seeB16-B17).

Cleaning, maintenance and orderingof spare parts

Before putting away or cleaning the grass trimmer, pull out the battery pack (B12 and B13).

7.1 Cleaning

. Keep all safety devices, air vents and the motorhousing free of dirt and dust as far as possible.Wipe the equipment with a clean cloth or blow itwith compressed air at low pressure.

. We recommend that you clean the device

. Clean the equipment regularly with a moist cloth and some soft soap. Do not use cleaning agents or solvents; these could attack the plastic parts of the equipment. Ensure that no water can seep into the device. . Remove deposits from the guard with a brush.

150-85-50430 18V CORDLESS LINE TRIMMIER LIST

Electrical Agencies Pty Ltd (trading as Electaserv Trading)Warehouse 2/97 Freight Street Lytton,QLD 4178Telephone: 07 3906 2920Email: sales@electaserv.com.au