actelis config guide
DESCRIPTION
readTRANSCRIPT
Configuration procedure of Actelis ML6xx modems
Pre-requisites:
Laptop with MAV software
Actelis console cable
Config steps:
Connect console cable between modem craft port and laptop COM port
Open MAV, select craft
Username: admin
Password: admin
Select COM port and observe data transfer indication at bottom right
The first modem is near end and HSL-1 modem is far end modem
Now select Calibrate and configure parameters as below
Modem will start calibration but if less copper pairs are connected it will prompt for “Start Calib.
Anyway”
Select that button to proceed and observe progress bar
After calibration is over, verify the HSL status