acdc 1915 instructions acdc lighting systems ltd ... · *ensure the unit is not powered during...
TRANSCRIPT
*Ensure the unit is not powered during installation (ie disconnect unit from mains).*Connect the LED unit to the ACDC1915 (see specific instructions for each LED unit).*Connect the DMX lead(s), as per diagram below*Set the address on the DIP switches (on the side of the Driver) with the required DMX address section). For testing purposes, set all switches to up (colour cycle mode).*Connect mains lead (if not already attached).*Power on.*If the ACDC 1915 is set to self test mode (address 511) the red LED (CH1) should light first followed by a slow mix green (CH2) then blue (CH3). See table A for special address functions.*Please note, for any changes in the address DIP switch to take effect, the ACDC1915 must be powered off and on.
ACDC 1915 Instructions
SYSTEM SCHEMATIC
MAINSIN
DMXINPUT
MAINSIN
MAINSIN
OUT PUTTO
LED'S
OUT PUTTO
LED'S
OUT PUTTO
LED'S
DMX LinkCat5 cable
Lucina fitting EB+RGB are pre fitted with Molex (8way receptacle) connector which can be directly connectedto 1915. Up to 1200mm of fittings may be connected to each DMX, Splitter blocks are available ifmultiple shorter fittings are to be connected:
J3
J2
J1
J4
Out put to fitting 3
Out put to fitting 2
Out put to fitting 1
From DMX
Any unused ports on splittermust have terminatorconnector in place
ACDC 1915ACDC 1915ACDC 1915Last unitmust be
set to'term'
Splitter Block detail
Lucina fittings
ACDC1915
Lucina
DMX
A maximum of 32 ACDC1915's can be chained together on any DMX universe. For repeaters please contact dimmer supplier
Problems? Call our Installation Helpline on ++44 (0) 845 862 6400�
www.acdclighting.co.uk
ACDC Lighting Systems Ltd, Innovation Works, Gisburn Road, Barrowford, Lancashire, BB9 8NB
Electrical Data
Input Power (Max) 54WInput Voltage 95-240V AC Output 350mASeries Rating 2 x 4-12 RatingDimming Control DimmableMin Dimmable Level 0%
DimensionsWeightTemperature rangeLifetime (MTBF)Max distance remote*Max Cable LengthStandardsIP Rating
45x282x57mm790g-10° to 40°C50,000 hrs35M70MCE, EN55015, SELV, FIP20
Mechanical Data
REV A - 20/11/09