a presentation of … size-selected compound semiconductor quantum dots by nanoparticle conversion...
TRANSCRIPT
A PRESENTATION OF …
SIZE-SELECTED COMPOUND SEMICONDUCTORQUANTUM DOTS BY NANOPARTICLE CONVERSION
BRENT WACASER, KIMBERLY A DICK, ZEILA ZANOLLI, ANDERS GUSTAFSSON, KNUT DEPPERT AND LARS SAMUELSON
Andrew Cardes 3/7/07
Claims of Innovation
Group at Lund University in Sweden. Development of a novel technology:
Called nanoparticle conversion Produce semiconductor QD Dot size, surface density, position, &
material system are all independently controlled
Spatial positioning realized
Strankski-Krastanow Growth
Nanoparticle Conversion Overview
Independent Particle Formation
Aerosol Evaporation Particle Generator
Results & Analysis
Figure 3. (a) AFM and (b) SEM image of QDs taken from a sample converted from In aerosol particles with an average diameter of 30 nm.The average QD height (measured by AFM) is 18±3 nm and the diameter (measured by SEM) is 31±3 nm. (c) SEM image of circular areas containing QDs produced from an EBL pattern and evaporation of 2 nm In followed by lift off. The pattern consisted of columns of circular areas separated by 2 μm on each side. In each column the circular areas were the same size. The diameter of the circular areas was decreased from left to right by 10 nm. The part of the pattern in the image results from 180, 170, and 160 nm circular areas.
Results & Analysis
Figure 4. TEM image of a InAsP QD converted from a nominally30 nm In particle on a Si substrate. In this sample, it was not possible to determine if this image is taken of a ‘whole’ QD or if the QD has been partially milled away during the sample preparation. The image is taken along a [11¯2] pole of the Si substrate. The contrast of the lattice fringes of the QD is somewhat blurred by the amorphous carbon surrounding the QD, which comes from the TEM sample preparation.
Figure 5. PL spectra taken from individual QDs converted from Innanoparticles at ∼5 K in a micro PL set-up. (a) Spectra from fourdifferent QDs converted from different sized In nanoparticles, withdiameters labelled to the left side of the spectra. (b) PL of the 30 nmQD depicted in (a) at lower laser excitation powers (the relativepower, P, is indicated to the left of the spectra). The highestexcitation power density of the laser, 1000 P, was used for all thesamples in (a). Note that there are at least two distinct peaks, 1.37 eVat lower and 1.41 eV at higher excitation power densities.
Conclusions
QD can be produced through a process that decouples dot size, density, and material limitations.
Dots with crystalline structure can be achieved with multiple materials.
Patterned arrays are possible. Quantum confinement can be
achieved. Blinking is observed.
Thank you!