6729 - tractorseats.com€¦ · 1060 u(% p+) s!˛-& s.,*!(,%)(pn: 8132 ped cih m˛#(.’ pn:...

1
1060 Uni Pro Seat & Suspension PN: 8132 PED CIH Magnum PN: 6098 Installation Guide 6729 Installation Instructions to Place a 1060 Uni Pro Seat and Suspension in a CIH 7100 Magnum Series with Air-Oil Suspension 1. Remove the original seat and suspension from the tractor. 2. Install the PED CIH Magnum using the original bolts. 3. Bolt the new seat and suspension assembly to the PED CIH Magnum angles using the included hardware. 4. Locate a power source and connect the suspension to power and ground. (See note below.) 001-CIH-6729-000 Note! Weight needs to be applied to the suspension to activate the pump. 1.800.328.1752 / www.tractorseats.com Customer Support Note! There are two wire connections in the 1060 Uni Pro, one for the Operator Presence Switch (OPS) and one for the compressor. The OPS wires come out of the back of the seat and the compressor wires are tucked in the boot. The OPS wires do not need to be connected for the seat to function. Connection of the OPS is only necessary if required by the machine or desired by the operator.

Upload: others

Post on 23-Aug-2020

1 views

Category:

Documents


0 download

TRANSCRIPT

Page 1: 6729 - tractorseats.com€¦ · 1060 U(% P+) S!˛-& S.,*!(,%)(PN: 8132 PED CIH M˛#(.’ PN: 6098 I˛!"a˙˙a"ˆ˚˛ G#ˆ 6729 I˛!"a˙˙a"ˆ˚˛ I˛!" # "ˆ˚˛! "˚ P˙a a 1060

1060 Uni Pro Seat

& Suspension

PN: 8132

PED CIH Magnum

PN: 6098

Installation Guide 6729

Installation Instructions to Place a 1060 Uni

Pro Seat and Suspension in a CIH 7100

Magnum Series with Air-Oil Suspension

1. Remove the original seat and suspension from the

tractor.

2. Install the PED CIH Magnum using the original

bolts.

3. Bolt the new seat and suspension assembly to the

PED CIH Magnum angles using the included

hardware.

4. Locate a power source and connect the suspension

to power and ground. (See note below.)

001-CIH-6729-000

Note!

Weight needs to be

applied to the suspension

to activate the pump.

1.800.328.1752 / www.tractorseats.comCustomer Support

Note!

There are two wire connections in the 1060 Uni Pro,

one for the Operator Presence Switch (OPS) and

one for the compressor. The OPS wires come out

of the back of the seat and the compressor wires

are tucked in the boot. The OPS wires do not need

to be connected for the seat to function.

Connection of the OPS is only necessary if required

by the machine or desired by the operator.