3G+ MiFi GSM Router

Model No.: iB-W3GM072G

UserzManual

Ver.: 2.0.0

2

FCC STATEMENT

This equipment has been tested and found to comply with the limits for a Class B

digital device, pursuant to part 15 of the FCC Rules. These limits are designed to

provide reasonable protection against harmful interference in a residential installation.

This equipment generates uses and can radiate radio frequency energy and, if not

installed and used in accordance with the instructions, may cause harmful

interference to radio communications. However, there is no guarantee that

interference will not occur in a particular installation. If this equipment does cause

harmful interference to radio or television reception, which can be determined by

turning the equipment off and on, the user is encouraged to try to correct the

interference by one or more of the following measures:

Reorient or relocate the receiving antenna.

Increase the separation between the equipment and receiver.

Connect the equipment into an outlet on a circuit different from that to which

the receiver is connected.

Consult the dealer or an experienced radio/ TV technician for help.

This device complies with part 15 of the FCC Rules. Operation is subject to the

following two conditions:

1) This device may not cause harmful interference.

2) This device must accept any interference received, including interference that

may cause undesired operation.

Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

FCC RF Radiation Exposure Statement

This equipment complies with FCC RF radiation exposure limits set forth for an uncontrolled environment. This device and its antenna must not be co-located or operating in conjunction with any other antenna or transmitter.

“To comply with FCC RF exposure compliance requirements, this grant is applicable to only Mobile Configurations. The antennas used for this transmitter must be installed to provide a separation distance of at least 20 cm from all persons and must not be co-located or operating in conjunction with any other antenna or transmitter.”

3

CE Mark Warning

This is a class B product. In a domestic environment, this product may cause radio interference, in which case the user may be required to take adequate measures.

Safety Precautions

Read the safety precautions carefully to ensure the correct and safe use of your wireless

device.

Do not switch on your device when the device use is prohibited or when

the device use may cause interference or danger.

Follow the rules or regulations in hospitals and health care facilities.

Switch off your device near medical apparatus.

Switch off your device in an aircraft. The device may cause interference

to control signals of the aircraft.

Switch off your device near high-precision electronic devices. The

device may affect the performance of these devices.

Do not attempt to disassemble your device or its accessories. Only

qualified personnel are allowed to service or repair the device.

Do not place your device or its accessories in containers with strong

electromagnetic field.

Do not place magnetic storage media near your device. Radiation from

the device may erase the information stored on them.

Do not put your device in a high-temperature place or use it in a place

with flammable gas such as a gas station.

Keep your device and its accessories away from children. Do not allow

children to use your device without guidance.

Use approved batteries and chargers only to avoid explosion.

Observe the laws or regulations on device use. Respect others’ privacy

and legal rights when using your device.

4

Contents

Safety Precautions ........................................................................ 3

Package Contents ......................................................................... 5

1.Overview: ................................................................................... 5

1.2. Product Features………………………………………………….6

1.3. Introduction to MiFi GSM Router ............................................ 7

2. Access to the Internet ................................................................ 9

3.Login to the 3G+ MiFi GSM Router .......................................... 10

4. Access Router through USB cable .......................................... 10

5. Battery Usage Details .............................................................. 11

6. Restore to Factory Default ....................................................... 12

7. Multi Device Access through Router ........................................ 13

8. Appendix: Specification ........................................................... 14

Contact Information ............................................................ 15

5

Package Contents:

The following contents should be found in the product packaging:

3G+ MiFi GSM Router

Li-ion Battery

Universal Power Adapter

Brief introduction:

iB-W3GM072G is GSM Router to access Internet Anytime & Anywhere through 2G/3G

Internet.

Router as used for a long time in a enclosed space, the temperature of the device will

increase. Then it will turn off automatically. When this phenomenon appears, please put it

in ventilation space to dissipate the heat and when the temperature of the device

decrease, you can use it as normal.

• Please change default (SSID) and change password for wireless security purpose.

Conventions

The Router or device mentioned in this User Guide stands for iB-W3GM072G without any

explanations.

Parameters provided in the pictures are just references for setting up the product, which

may differ from the actual situation.

1. Overview

iBall Baton 3G+ MiFi GSM Router is compact size pocket / travel ideal for travel users.

2G/3G GSM Internet - Access Internet with mobility, Wi-Fi Ready - Personal Hotspot

Compact design with Li-ion battery ideal for Travel use

Mobile Hotspot with LED display to identify Network & Signal

6

1.1 Product Features:

Complies with IEEE802.11 b/g standards

Support 802.11n wireless connection

SIM slot GSM Router - 2G/3G Internet access

High Speed transmit rate upto 7.2Mbps HSDPA & 5.76Mbps HSUPA

2G/3G Frequency band HSPA / UMTS :2100Mhz

GSM/ GPRS/ EDGE: 850Mhz, 900Mhz, 1800Mhz & 1900Mhz

Internet sharing support up to 5 Wi-Fi users and 1 USB connection

32GB Micro SD card slot

With 1500mAH Li-ion battery

Working 4Hours , Standy time :16Hours

Charging Time: Max. 3 Hours (USB 5VDC, 750mAh)

SMS

Wireless security as WPA-PSK & WPA2-PSK

In-build DHCP Server

Internal Antenna

OS Compatible : WinXP, Vista, Win7, Win8 & MAC OS X10.5.0 up to 10.7.0

7

1.2 Introduction of 3G+ MiFi GSM Router

Device state

Item Status

Insert a SIM card No SIM card or SIM card falut

No service No Signal or SIM card fault

Internet Internet Connecting

No Internet Connection

WiFi

WiFi is Opened

Established WiFi Connection

WiFi is Closed

Message Unread messages

No unread message

Signal RSSI from weak to strong

Battery Level Battery Level from weak to strong

Charging

Boot charge from charging to saturation

Charge level from weak to strong with no booting

1.Reset Button

2.USB Interface

3.Power Button

4. iBall Baton Logo

5. Product Name

6.Total Internet Traffic Statistics

7.Identification of ISP

8.RSSI

9. Internet Access Type: 2G / 3G

10.WiFi

11. Internet : Connected / Disconnected

12.SMS Indication

13.Battery Level

14.Internet Connected Time Statistics

8

1.3 Install the SIM card, Micro SD card and battery

Make the card with corner side towards top left, then slide the card into slot.

System Requirements

CPU: Pentium 500MHz or above.

Hard Disk: 50MB available space.

Operating System: Windows 8/7/VISTA/XP (SP2 and above), Mac OS X 10.4.9 and

Later, Up to X10.6.0.

Display Resolving Power: 800 × 600 pixels or above (1024 × 768 is recommended).

Interface: Standard USB 2.0 interface.

Web Browser: Internet Explorer 6/7/8, Safari3/4/5.

One or more computing devices that support Wi-Fi (802.11b/g).

9

2. Access to the Internet

Description: By default, iB-W3GM072G has been complete pre-management

parameters, you can quickly access to the Internet by the following steps. As for the

detailed operation, please refer to the help information of “Management websites”.

Step I: ON / OFF of iB-W3GM072G

• Long press button for 3 seconds, then iB-W3GM072G is ON.

• Long press button for until it shows “Shutdown”, and then iB-W3GM072G is

OFF.

Note: Please don’t take out the battery directly to turn it off, you must long press

button until all indicator lights completely down, then you can take out the battery.

Step II: Establish a WiFi connection (Connect Computer for example)

1. Please make sure is ON.

2. Choose Start---- Control panel----Network

Connections---Wireless Network Connection.

Description: Before establishing a Wi-Fi connection,

you must ensure that the computer has been

equipped with a wireless card. If the computer

indicates the existence of wireless networks, then the

wireless card can be used. Otherwise, you need check whether the wireless card can

work.

3. Click to check the available wireless networks,

there will show the list of network connections.

4. Select the SSID which consistent with the

iB-W3GM072G and click .

Step III: Access to the internet

When the connection between user terminal and iB-W3GM072G is established, internet

will be available immediately.

10

3. Login to the 3G+ MiFi GSM Router

1. Confirm the connection for iB-W3GM072G with WiFi or the computer is good.

2. Open the browser, enter http://192.168.1.1 in the address field

3. Input username: admin and password: admin, then click “OK”.

Description: If you can't visit the management web page, please restart your

iB-W3GM072G and then you can visit without any issues.

11

4. Wired Connectivity through USB Cable

For Win 7/8/XP OS, driver will install automatically. Wait until driver installation over, you

could connect to Internet directly.

Note: It needs to install the driver in Windows XP SP3 systems, steps:

• Without SIM card. Under the Windows SP3 system, connect to computer via USB cable

connection, popup Window of the driver installation to install automatically, till “My

computer” popup and open it, copy the files of to the computer,

then shut iB-W3GM072G down.

• Open iB-W3GM072G when plugging the SIM card and wait for its identification , connect

to USB cable, then automatic pop-up RNDIS driver installation window,

choose click choose

click Choose 32bit or 64bit from folder ,Click

, click and then , then could surf internet。

5. Battery Usage Details

Charge battery

If the battery has not been used for a long time, please charge it to saturation state before

use.

• Use the matched USB cable to connect iB-W3GM072G with the computer, then the

charging icon on the screen shows the battery is charging.

• Using USB cable to charge battery in shutdown state, the charging icon will

automatically go out after it appears, If you want to open iB-W3GM072G, firstly to press

button to wake up iB-W3GM072G, then to long press button to open

iB-W3GM072G.

Note: If the battery runs out completely, then when you connect the USB cable to charge,

the screen will not show the charging icon. It needs to wait for about 1 minute before

charging icon appears for charging tips.

Power saving mode

Every 30 seconds iB-W3GM072G will be in the idle state. The screen light will be off. Then

in the state of idle, you just need to press button to wake iB-W3GM072G， the

screen light will be lighting all the time.

12

Installation of Micro SD card

1. Open the Micro SD card slot cover.

2. Input the Micro SD card.

3. Pin the SD card slot cover and push the cards then lock it in the slot.

6. Restore to Factory Default :

If you forget the SSID of the Router or the username and password of the Router, please

take the following methods to restore Wi-Fi default values:

Method I: RESET button

Press the RESET button for 3 seconds and then release it after the screen shows “Factory

default”, the screen will off.

Just wait for a moment, iB-W3GM072G will automatic restart. After restart the Router

will be in Factory Defaults Mode.

Method II: Plug and play function

• Directly connect to the computer, log in the administrator then you can view or change

the SSID’s username and password.

13

7. Multi-device access

High Speed download transmit rate up to 7.2Mbps Download & 5.76Mbps Upload

Access Internet through Wireless mobility to 5 Wi-Fi device.

Access Internet through wired USB connection

14

8. Appendix: Specification

Device Type WCDMA 3G Wireless Router

Network Type 3G：UMTS/HSDPA/HSUPA

2G：GSM/GPRS/EDGE

Frequency Band UMTS/HSDPA/HSUPA：2100MHz

GSM/GPRS/EDGE：850/900/1800/1900MHz

Data Transfer Rate Max7.2Mbps(DL)

Max5.76Mbps(UL)

Interface Micro USB

Memory Card Micro SD card support up to 32GB

Other Features SMS , Storage

Support System Windows & Mac 10.8.2*

Color White & Grey

Size 87*47*14.55mm

Weight 71g

Other parameters

Wi-Fi 802.11b/g

Support 5 Wi-Fi users

WPA-PSK encryption

Charging Charging interface：Micro USB 5V 750mA

Battery

Type：Detachable Li-ion battery

Capacity：3.7V/1500mAh

Standby time：16H(3G）

Working time：4H(3G)

Standard charging time：2.5H

15

COPYRIGHT & TRADEMARKS

Specifications are subject to change without notice. iBall Baton is a registered

trademark of Best IT World (India) Pvt. Ltd. Other brands and product names are

trademarks or registered trademarks of their respective holders.

No part of the specifications may be reproduced in any form or by any means or used

to make any derivative such as translation, transformation, or adaptation without

permission from Best IT World (India) Pvt. Ltd. All rights reserved.

Note: For any technical help on iBall Baton products please contact

support.baton@iball.co.in

www.iBallBaton.com | www.iBall.co.in