3.3 plc.pdf
TRANSCRIPT
-
3. AUXILIARY FUNCTION AND SYSTEM SETTINGS
DELTA ELECTRONICS, INC. ALL RIGHTS RESERVED 3-3
If there is an error detected in the grammar, it will display (ERROR CODE). User can check with Chapter 4.3 to find out the error codes and the corresponding reasons.
Pressing key to return to the MAIN MENU.
3.3. PLC and HPP02 Program Verifications There are two selections in this function: 1. To verify both program contents of PLC and
HPP02. It can be used in the PLC ONLINE mode. 2. To verify both program contents of M_CARD and HPP02. It can be used in the three modes.
Item 1: To verify both program contents of PLC and HPP02.
Using key to the item or input 5 and then press
key.
Using key to select item 1 or input 1 and then
press key to verify with MPU program.
Pressing key to verify both program contents of PLC and HPP02.
Pressing CLEAR key to cancel and return to the MAIN MENU.
Program contents of PLC and HPP02 are the same.
Pressing key to cancel and return to the MAIN MENU.
Display will show the difference line number once a mismatch is detected and stop verifying.
Pressing key to cancel and return to the MAIN MENU.
Item 2: To verify both program contents of M_CARD and HPP02.
Using key to the item or input 5 and then press
key.
-
3. AUXILIARY FUNCTION AND SYSTEM SETTINGS
3-4 DELTA ELECTRONICS, INC. ALL RIGHTS RESERVED
Using key to select item 2 or input 2 and then
press key to verify with M_CARD program.
Pressing CLEAR
key to return to main menu when there is no M_CARD.
Pressing key to verify program contents of M_CARD and HPP02.
Pressing CLEAR key to cancel and return to the MAIN MENU.
Program contents of M_CARD and HPP02 are the same.
Pressing key to cancel and return to the MAIN MENU.
Display will show the difference line number once a mismatch is detected and stop verifying.
Pressing key to cancel and return to the MAIN MENU.
3.4. Parameters Settings There are four items in this function: 1. Setting the program capacity of the HPP02. 2. Display the operation version of HPP02. 3. Setting the PLC password. Item 1: Setting the program capacity. After HPP02 connects to PLC, executing the function of Program Read. It will display
PLC program memory capacity. User can select item 6 PARAMETER SET to check PLC memory capacity. You can check if memory capacity of HPP02 is matched with PLC by execute item
Program Write-in in MAIN MENU. If they are mismatch, the display will show the message as following.
COVER.pdf 1