2a d110 igita reamplifie utpu onnection iagra whe se a it
TRANSCRIPT
2A
McIntosh Laboratory, Inc. 2 Chambers Street Binghamton, New York 13903-2699 Phone: 607-723-3512 FAX: 607-724-0549 Part No. 04172600
D1100 Digital Preamplifier Output Connections Diagram (when used as a DAC with an Analog only Preamplifier)
Note: Refer to the D1100 Owner’s Manual page 8 for additional connection information.
Connection Legend: Data Cable*- Digital Signal Cable - Sensor/Keypad Cable - RS232 Cable - Power Control Cable* - Ground Wire - Audio Signal Cable - AC Power Cords - Video Signal Cable - Loudspeaker Cable - RF Signal Cable - * 2 conductor shielded with 1/8 inch stereo mini phone plug on each end.
+
Connect to AC Outlet
Connect to AC Outlet
Right Loudspeaker System
Left LoudspeakerSystem
-+-
Power Amplifier - Primary Room
Analog Preamplifier
Connected to the Analog (Preamplifier) Controller Main Power Control Out Jack
TO CONTROLLER RIGHT INPUT
TO CONTROLLER LEFT INPUT
2B
McIntosh Laboratory, Inc. 2 Chambers Street Binghamton, New York 13903-2699 Phone: 607-723-3512 FAX: 607-724-0549
D1100 Digital Preamplifier Output Connection Diagram (when used as a stand alone Preamplifier)
6.6
Note: Refer to the D1100 Owner’s Manual page 9 for additional connection information.
Connection Legend: Data Cable*- Digital Signal Cable - Sensor/Keypad Cable - RS232 Cable - Power Control Cable* - Ground Wire - Audio Signal Cable - AC Power Cords - Video Signal Cable - Loudspeaker Cable - RF Signal Cable - * 2 conductor shielded with 1/8 inch stereo mini phone plug on each end.
+
Connect to AC Outlet
Power Amplifier - Secondary Room
Connect to AC Outlet
Connect to AC Outlet
Right Loudspeaker System
Left LoudspeakerSystem
Right Loudspeaker System
LeftLoudspeaker System
-+-+ -+-
Power Amplifier - Primary Room
From Phono Preamplifier PWR CTRL Trig Out