2007-2008 Suzuki SV650Installation Instructions

Parts List1 Ignition module1 Installation Guide2 Velcro® Strip1 Alcohol Swab

You can also download the Power Commander software and latest maps from our web site at:www.powercommander.com

The ignition MUST be turned OFF before installation!This module is intended to be used in conjunctionwith Power Commander #337-411

PLEASE READ ALL DIRECTIONS BEFORE STARTING INSTALLATION

Before this module can be used the Power Commander may need to be updated.

(see included instructions)

2007-2008 Suzuki SV650 - PCIII USB - 16-57 www.powercommander.com

Dynojet Research 2191 Mendenhall Drive North Las Vegas, NV 89081 (800) 992-4993 www.powercommander.com

1 Remove the seats.2 Prop the front of the fuel tank up.3 Remove the air box.4 Place the ignition module in the tail

section and route the harness downthe left hand side of the bike.

5 Unplug the stock wiring haress fromthe left hand side coil (Fig. B).

Fig

. A

Fig

. B

2007-2008 Suzuki SV650 - PCIII USB - 26-57 www.powercommander.com

Unplug

6 Connect the ORANGE colored wiresfrom the ignition module in-line ofthe stock coil and wiring harness(Fig. C).

7 Repeat steps 5&6 for the right handcoil using the YELLOW coloredwires from the Ignition Module.

Fig

. C

10 Attach the ground wire from theIgnition Module to the negative sideof the battery (Fig. F).

11 Reinstall air box and fuel tank.12 Plug the white 10 pin connector from

the ignition module into the expansionport of the PCIII. If you are using aquickshifter then unplug the quick-shifter from the PCIII and connect tothe expansion port of the igntionmodule harness.

Fig

. E

Fig

. F

8 Unplug the stock crank pickup coilconnector (Fig. D). This is a BLACK2 pin connector.This connection is located on the lefthand side of the tail section. You mayhave to pull the tail section away fromthe frame to access it.

Fig

. D

2007-2008 Suzuki SV650 - PCIII USB - 36-57 www.powercommander.com

Ground wire from IM

9 Plug the Igniton Module harness in-line of the stock wiring harness(Fig. E).

Unplug crank connector

Wiring harness from module

Stock wiring harness