i421-411 2006 Yamaha R1 - PCIII USB - 1

2006 Yamaha R1Installation Instructions

Dynojet Research 2191 Mendenhall Drive North Las Vegas, NV 89081 (800) 992-4993 www.powercommander.com

Parts List1 Power Commander1 USB Cable1 CD-ROM1 Installation Guide1 Power Adapter2 Power Commander Decals2 Dynojet Decals2 Velcro® Strip1 Alcohol Swab

You can also download the PowerCommander software and latest mapsfrom our web site at:

www.powercommander.com

The ignition MUST be turnedOFF before installation!

PLEASE READ ALL DIRECTIONS BEFORE STARTING INSTALLATION

Button Adjustment Display

Faceplate Buttons

USB PortExpansion Port

1 Remove the main seat and thepassenger seat.

2 Prop the front of the fuel in theup position.

3 Lay the PCIII in the tail sectiontemporarily. Route the wiresunder the tail section and gotowards the front of the bike.

4 Locate the connector from themain wiring harness to the injector rail and uplug this connector (Fig. A).

NOTE: This connector is grey in color.

5 Plug the connectors from thePCIII in-line of the stock wiringharness (Fig. B).

6 Bolt the fuel tank down intoposition.

7 Remove the two bolts on the lefthand side of the battery holddown bracket and loosen theright hand bolts enough to routethe PCIII harness underneath it(Fig. C).

8 Reinstall the bracket.

Fig.

AFi

g. B

Fig.

C

i421-411 www.powercommander.com 2006 Yamaha R1 - PCIII USB - 2

View from topPCIII connectors

Stock connectors

Unplug this connector

Route the harnessunderneath this bracket

PCIII harness

9 Attach the ground wire from thePCIII to the negative side of thebattery (Fig. D).

10 Install the PCIII in the rear section of the trunk using thesupplied velcro (Fig. E). Makesure to clean both surfaces withalcohol first.

11 Make sure all the wires are routed properly.

12 Reinstall the main seat and thepassenger seat.

Fig.

D

i421-411 www.powercommander.com 2006 Yamaha R1 - PCIII USB - 3

Fig.

E

Ground wire from the PCIII.